HALO HAL-CLR-0001 Thermoelectric Cooler Bag Instruction Manual
- June 13, 2024
- HALO
Table of Contents
HALO HAL-CLR-0001 Thermoelectric Cooler Bag
INCLUDED ITEMS
- HALO Hybrid Cooler/Heater Bag
- DC Cable
- AC Adapter
FEATURES
-
Employs reliable solid-state thermoelectric technology. The fans are the only moving parts. No CFC’s or coolant to leak.
-
Operates on 12 Volt DC power. Typical current draw: 4.5 amps DC.
With the optional AC adapter it can be operated from a 120 Volt AC wall outlet. AC adapter current draw: 1 amp AC. -
Typical cooling performance is between 15°C/27°F and 22°C/40°F below ambient temperature.
OPERATING INSTRUCTIONS
-
Just plug your cooler into the 12 volt power receptacle in your vehicle (recommended). The current consumed is about 4.5 amps. When your vehicle is running and the electrical system is operating properly, your cooler will operate continuously without discharging the battery. When the battery is not being charged, the cooler should not be operated for more than 4 hours.
-
The cooler can be operated continuously from a 110/120 volt AC wall outlet using the optional HALO Hybrid Cooler/Heater Bag AC Adapter.
For best results, precool your unit and the food and beverages before placing them in your cooler. If the cooler is loaded with warm material, it will require at least 12 hours to cool the contents.
SAFETY PRECAUTIONS
CAUTION – Read all safety information before using this product. Failure to follow these instructions may result in electrical shock, explosion, fire which may result in serious injuries, death or property damage.
- The HALO Hybrid Cooler/Heater Bag is designed to operate on 12 volts direct current only. Do not attempt to connect it directly to 1 10/120 volt AC wall socket without using the optional HALO Thermoelectric Cooler Bag Power Adapter.
- Do not use the HALO Hybrid Cooler/Heater Bag with any other AC adapter device other than the optional HALO Hybrid Cooler/Heater Bag Power Adapter. Failure to do so may invalidate warranty and pose a hazard.
- Do not operate the HALO Hybrid Cooler/Heater Bag in direct sunlight or in hot enclosed areas such as automobile trunks. The cooler generates heat and must have free air circulation to perform properly.
- Do not block the ventilation area of the control panel. Free flow of air is necessary for effective heat transfer. Regularly check the panel for dirty or clogged vents.
- Ensure that the 12V power socket is clean and safeguarded by a correctly fused circuit.
- Push plug firmly into the 12V power receptacle to ensure good contact.
DO NOT Pour Water or Ice Into the Cooler/Heater Bag
DO NOT Block Air Intake
MAINTENANCE AND STORAGE INSTRUCTIONS
- Keep cords and 12V power sockets clean at all times. Dirt particles in the socket may affect performance.
- To clean wipe the inside with a warm damp cloth or sponge. Do not use harsh or abrasive cleaners. A mild soap should be sufficient, but if stains or odors remain, household bleach or baking soda may be added to the cleaning solution. Keep the lid open for several hours after cleaning to allow the interior to dry thoroughly and to prevent odors from forming in the cooler.
- For long periods of storage, a small container of baking soda or charcoal, placed inside, will eliminate objectionable odors.
SPECIFICATIONS
HALO Hybrid Cooler/Heater Bag
Model………………………………………………………………………………………………….XXXXX
Cooling Mode Input………………………………………………………………..12V/50-62W
Heating Mode Input………………………………………………………………..12V/45-67W
Cooling Temperature…………………………………59°F ± 35.6°F below ambient
Heating Temperature……………………………………………………………..140°F ± 41°F
Operating Temperature Range……………………….32°F – 104°F (0°C – 40°C)
Dimensions…………………………………………………………………12 x 10 x 10.5 inches
Weight…………………………………………………………………………………………………….TBD
COMPLIANCE WITH FCC REGULATION
This device complies with part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
• Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
CAUTION
To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be used with certified peripherals and shielded cables. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables may result in interference to radio or reception.
MODIFICATION
Any changes or modifications of this device could void the warranty.
LIMITED WARRANTY
At HALO, we are dedicated to making the best quality products. To back this
up, this product is warranted. HALO warrants its products to be free from
defects in material and workmanship under normal use. During the first 90 days
from date of purchase, HALO will repair or replace the defective product. This
warranty does not affect any statutory rights that you may be entitled to.
Keep a copy of your purchase receipt as proof of purchase.
For all questions about the warranty or exchange requests, please call
888-907-6274 or visit our website at
www.HALOPOWER.com.
CUSTOMER SUPPORT
All copyrighted and copyrightable materials, including, without limitation,
the logo, design, text, graphics, pictures, copy writing and the selection and
arrangement (“Materials”) thereof are ALL RIGHTS RESERVED Copyright © 2022
Alliance Sports Group, L.P.
Alliance Consumer Group
700 Henrietta Creek Road
Roanoke, Texas 76262
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>