ROHL Kitchen and Bath Faucet Instruction Manual

Table of Contents

Flush the hot and cold water lines before faucet installation.
Install the base D1.
Guide the handspray hose B2 through the top side of the faucet body.
Thread in the hot and cold water supply lines B1 by rotating them by hand only.
Install the faucet into the deck, fitting A1 washer.
Secure the faucet to the deck as shown.
Install the weight F1 on the hose and secure the hose attachment to the mixed water outlet tube using connector G1 and seal washer H1.
Install the shower as shown.
Connect the hot and cold supply lines to the hot and cold inlets, making sure not to damage the supply lines.
To service the aerator, turn it off and follow the instructions provided. Tools not included: 3/32
To replace the faucet cartridge, follow the instructions provided. Tools not included: 3/32, 1, 4, 6 lb ft

Maintaining Your Faucet Finish

No matter which finish you select, here are a few simple steps to keep your ROHL kitchen and bath fixtures looking beautiful for years:

For water spotting on polished chrome, use Simichrome paste.

Minimum dynamic pressure…………………………. 7.0 PSI
Recommended operational pressure (static)……….. 14.0 – 70.0 PSI
(ATTENTION: when pressure exceeds 70.0 PSI, we recommend the installation of a pressure reducer)
Maximum operational pressure (static)……………… 150 PSI
Maximum test pressure (static)……………………….200 PSI
Maximum hot water temperature…………………….170°F
Recommended hot water temperature………………140°F (for safety and energy saving)
Hot water connection……………………………….. left
Cold water connection……………………………….. right

ROHL-Kitchen-and-Bath-Faucet-FIG-3

Flush hot and cold water lines before faucet installation.
Install the base “D1”.
Guide handspray hose “B2” through top side of faucet body.
Thread in hot and cold water supply lines “B1” by rotating lines by hand only
Install faucet into deck, fitting “A1” washer
Secure faucet to deck as shown
Install weight “F1” on hose and secure hose attachment to mixed water outlet tube, with connector “G1” and seal washer “H1”.
Install the shower as shown
Connect hot and cold supply lines to hot and cold inlets.
Pay attention not to damage supply lines.
Servicing the aerator.
Replacing faucet cartridge.
Replacing faucet cartridge.

No matter which finish you select, here are a few simple steps to keep your ROHL kitchen and bath fixtures looking beautiful for years:
Daily, pat the fixture dry with a soft cloth after each use – this is the single most important care you can give any finish!
Occasionally, use a mild clear liquid soap with a neutral PH balance and water to gently clean your faucet. Do not use Dove or anti-bacterial soap. these products will leave a residue that could harm your finish.
When necessary, a 50/50 solution of vinegar and water can be applied to remove hard water deposits. Do not soak the product in the solution.
Vinegar is a mild acid which will harm the finish with prolonged contact.
Avoid all cleaning products that contain ammonia, bleach, and alcohol.
They may damage the finish. Use clear liquid soap with a neutral PH balance.
Care and use products mentioned in this brochure may be ordered through your local ROHL retailer.