BELL HOWELL 8553 Wireless Video Doorbell User Manual
- June 13, 2024
- BELL HOWELL
Table of Contents
WIRELESS VIDEO DOORBELL
2.4 GHz Wireless Video Door Intercom System
USER’S MANUAL
PARTS IDENTIFICATION:
- Camera Unit
- Camera Sensor
- Infrared LED
- Indicator LED
- Speaker
- Microphone
- Call Button
- Lithium Polymer Battery (built-in)
- Receiver Unit
- 2.4″ TFT LCD Display
- Indicator light
- Speaker
- Power Button
- Menu Button
- Talk Button
- Sync (Pairing) Button (located on the back of unit)
- Battery Door
- AC Adapter
- Double Sided Adhesive Foam
- Metal Wall Bracket
- Screws
- Charging Dock
BATTERY INSTALLATION (for Camera Unit):
Sync (Pairing) Button
- To open the battery compartment, turn knob located on the battery compartment door counterclockwise. Keep turning until able to remove the door.
- Insert 4 AA Batteries (Alkaline recommended). Observe polarity.
- Replace battery door, turn the knob clockwise to close. Keep turning until tight.
SET-UP:
NOTE: First, you must sync both units prior to operation:
Camera Unit: Press Sync Button for 5 seconds, the indicator light will
start to flash.
Receiver Unit: Press the Menu Button for 5 seconds. Once you hear a long
beep, the syncing action is complete.
INSTALLATION of Camera Unit (waterproof ):
NOTE: You have 2 options for mounting the Camera Unit:
Using Screws (for cement/brick walls): First, mount the Metal Bracket
onto wall or door using the provided screws. Next, attach the Camera Unit to
the bracket. See below Diagram for reference.
Using double-sided adhesive foam (wood or metal door): First, peel one
side of the adhesive foam piece and adhere it to the back of the metal
bracket. Peel the other side and adhere the metal bracket to the door. See
below Diagram for reference.
Note: We do not recommend installing the device on metal door, as it may
interfere with the reception.
USAGE:
- When someone presses the Call Button on the Camera Unit, the Receiver unit will play a door chime and the video will come on.
- Home owner must press the Talk Button on the Receiver Unit to talk back to the visitor. When done speaking, home owner must release the Talk Button to let the visitor answer.
Video Memory Visitor Log
- Home owner has an ability to go back and check the video visitor log.
- Press the Menu Button once and then press UP or DOWN key to review the visitor log.
Adjusting Picture
When in Call Mode, press the UP or DOWN key to adjust the picture quality.
Volume Control
Press the +/- Button to adjust the sound level.
CHARGING RECEIVER UNIT:
- Place the Receiver Unit into Charging Dock. Plug one end of the AC Adapter into the back of the Charging Dock. See Diagram on next page.
- User has an option of charging the Receiver Unit by plugging it directly into the bottom of the unit.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: The manufacturer is not responsible for ANY interference, for example
RADIO or TV interference, caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to operate the
equipment.
BELL + HOWELL® Wireless Video Doorbell STYLE NO. 8553
Distributed under license by Emson® NY, NY 10001
©2011 All Rights Reserved. Printed in China.
BELL + HOWELL® is a registered trademark of BHH, LLC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>