ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance Instruction Manual

June 9, 2024
ROHL

rohl logo

ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance

ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure
Balance

HELPFUL TOOLS

For safety and ease of installation, the use of these helpful tools is recommended.

ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance
1

Parts List

ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance
2

  • A. Valve Assembly
  • B. Valve Test Plug
  • C. Valve Cover and Plaster Ground
  • D. Mounting Bracket Assembly
  • E. Wall Plate
  • F. Cartridge
  • G. Decorative Sleeve
  • H. Retaining Nut
  • I. Rosette
  • J. Handle
  • K. Handle Set Screws (x2)
  • L. Handle Plug Buttons (x2)

WALL

STANDARD WALL

ACRYLIC WALL

INSTALLATION INSTRUCTION

  1. ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance 5
  2. Remove test plug (B) from Valve Assembly. Turn off stops. Remove test plug for flushing.
  3. Suggested: Open stop. Flush the hot and cold supplies 20 seconds each.ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance 6
  4. With stops in the close or vertical position, install Cartridge (F) into the Valve Assembly. Red inlet will be on the left, blue inlet will be on the right. Ensure that the ends of the Cartridge are installed correctly. Red marking on the Cartridge to be installed on the hot water line. Blue marking on the Cartridge to be in-stalled on the cold water line.
  5. Slide Cartridge Nut onto Cartridge and hand tighten.
  6. Do not overtighten the cartridge nut. Mark a line on the nut and body. With a wrench, rotate the nut closed 1/4 turn. Turn on the stops and check for leaks.ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance 8
  7. Install Decorative Sleeve (G) and Retaining Nut (H). Tighten nut, hand tight only.
  8. Install the Mounting Bracket Assembly (D) and secure with Mounting Bracket Assembly Screws (x2). Shorten the screws as needed. Apply sealant to the edges. ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance 9
  9. Install the Wall Plate (E) onto the Mounting Bracket Assembly. Once the Wall Plate is installed, install the Rosette (J).
  10. Install the Handle (J). Once the Handle is installed, insert and tighten the Handle Set Screws (K) (x2) to the underside of the Handle. Once the Handle is secured tightly, insert the Handle Plug Buttons (L) (x2).ROHL TAC23W1LMAPC Arcana Thermostatic and Pressure Balance 10

For warranty or additional information, contact:

QUEBEC
houseofrohl.ca/support 1-866-473-8442

U.S.A.
houseofrohl.com/support 1-800-777-9762

ONTARIO

houseofrohl.ca/support 1-800-287-5354

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ROHL User Manuals

Related Manuals