Westinghouse W-781 LED Retrofit Lamp Instruction Manual

: June 13, 2024
: Westinghouse

Table of Contents

Westinghouse W-781 LED Retrofit Lamp
INSTALLATION AND SAFETY INSTRUCTIONS
INSTRUCTION
WIRING DIAGRAMS
Replacing Self-Ballasted CFL Lamp
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Westinghouse W-781 LED Retrofit Lamp

INSTALLATION AND SAFETY INSTRUCTIONS

CAUTIONS

WARNING – Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaire electrical systems. If not do not attempt installation. Contact a qualified electrician
WARNING – Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or
drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire
SUITABLE FOR WET LOCATION
Operating temperature: -25°C to 45°
SUITABLE FOR USE IN ENCLOSED LUMINAIRES.

MINE LAMP COMPARTMENT

DIMENSIONS: 16.2″x10″×10″
Don’t stare at the bright light for long periods of time, as it may cause injury to your eyes.

This device is not intended for use with an emergency exit. enclosure of wiring or electrical components during kit installation. or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects. lamp holder terminals to make new connections at lamp holder terminals. Instead, installers should cut the existing pholder and make new electrical connections to lamp holder lead wires by employing applicable connectors. should only be used on branch circuits permitted in Section 210.6 of the US National Electrical Code for EX39

JMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY AUTHORITIES HAVING JURISDICTION. PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE APPLICABLE AND APPROPRIATE ELECTRICAL CODES. THE INSTALLATION GUIDE DOES NOT SUPERSEDE LOCAL OR NATIONAL REGULATIONS FOR ELECTRICAL INSTALLATIONS.

This device complies with Part 15 of the FCC rules and has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

INSTRUCTION

STEP 1: Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance:
STEP 2: Remove the existing lamp. Dispose of the lamps per local requirements.
STEP 3: Disconnect and remove the existing ballast, capacitor, and ignitor. Dispose of the components per local requirements.
STEP 4: Connect the Line wire (Line/Hot) to the center contact (eyelet) of the lamp holder.
STEP 5: Connect the Neutral wire (Common) to the shell of the lamp holder.
STEP 6: Insert and screw the LED Retrofit lamp into the lamp holder.
STEP 7: Close the wiring compartment. Watch to be sure the wires are not pinched, bound, or crimped when closing the compartment:
STEP 8: Switch on the power.