THUREN FABRICATION 1998.5 Active Rate Swaybar Instructions
- June 13, 2024
- THUREN FABRICATION
Table of Contents
FABRICATION 1998.5 Active Rate
Sway bar Instructions
Thuren Fabrication
1998.5 – 2002 sway bar
These instructions are applicable to the following Trucks:
- 1998.5 – 2002 Ram 2500
- 1999 – 2002 Ram 3500
Applicable Part Numbers:
- (TF-FSWBK-9802) 1998.5 – 2002 0” – 4” Lift (6.75“ Links)
- (TF-FSWBK-9802-4UPLIFT) 1998.5 – 2002 4” – 8” Lift (9.25” Links)
-
Remove Stock/Previous Sway Bar
• Disconnect Sway Bar Links from Axle and Sway Bar
• Remove hardware from Sway Bar mount on frame.
• Remove Sway Bar from truck
1998.5 – 2002 Sway Bars will come with (2) collars to keep the sway bar centered between frame mounts and the frame, keeping the Sway Bar from moving side to side.
warning
1998.5 – 2002 mounting configuration can vary. Mounting the end links as vertical as possible is the end goal at ride height. -
Installing Sway Bar
• Install Sway Bar with “THUREN” sticker facing up
• Lift Sway Bar into position and hand tighten frame mount hardware
• Torque frame mount hardware to 45 Ft/Lbs -
Install End Links
• Ensure the Sway Bar End Links Sleeve Flange is against the Sway Bar and Axle mounting surface.
• install Sway Bar End Links.
• Torque End Link Hardware to 100 Ft/Lbs -
Installing Collars
• Collars should be installed after Sway bar and End Links have been installed.
• Collars can be mounted on the inside of the frame mounts or the outside of the frame mounts. whichever space allows.
https://www.thurenfabrication.com/pages/qr-code-for-our-store?r=QZ5Y4HJECX1M
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>