Linksys MX4300/MX4300S Home WRK For Business User Guide

Linksys MX4300/MX4300S Home WRK For Business User Guide

Wireless Regulatory Information

CC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and devices
• Connect the equipment to an outlet other than the receiver’s
• Consult a dealer or an experienced radio/TV technician for assistance

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

2.4GHz operation of this product in the USA is firmware limited to channels 1 through 11. The device for the band 5150-5250 MHz is only for indoor usage to reduce the potential for harmful interference to co-channel mobile satellite systems.

FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 35 cm between the radiator and your body. This device and its antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.

Innovation, Science and Economic Development Canada Statement

CAN ICES-003(B) / NMB-003(B)
This device complies with ISED’s license-exempt RSS standards. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.

Innovation, Science and Economic Development Canada Radiation Exposure Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 35 cm between the radiator & your body.

This device and its antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with ISED multi-transmitter product procedures.

Restrictions in the 5 GHz Band

The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to cochannel mobile satellite systems. This device has been designed to operate with an antenna having a maximum gain of 3.1 dBi and 5.1 dBi at 2.4 GHz and 5 GHz respectively. Antenna having a higher gain is strictly prohibited per regulations of ISED. The required antenna impedance is 50 ohms.

The maximum antenna gain (Please see the table below) permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply with the EIRP limit and the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the EIRP limits specified for point-to-point and non-point-to-point operation as appropriate because high power radars are allocated as primary users (meaning they have priority) in 5250-5350 MHz and 5650-5850 MHz, these radars could cause interference and/or damage to license exempt LAN devices. The worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated.

No.| Antenna Type| For 2.4 GHz Gain (dBi)| For 5 GHz Gain (dBi)| Antenna Connector
---|---|---|---|---
1| Dipole| 3.1| 5.0| I-PEX (MHF)
2| Dipole| 2.8| 5.1| I-PEX (MHF)
3| Dipole| N/A| 3.8| I-PEX (MHF)
4| Dipole| N/A| 4.1| I-PEX (MHF)
5| Dipole| N/A| 4.1| I-PEX (MHF)
6| Dipole| N/A| 3.8| I-PEX (MHF)

Additional requirements for the band 5600-5650 MHz Until further notice, devices subject to this Section shall no
be capable of transmitting in the band 5600-5650 MHz, so that Environment Canada weather radars operating in this band are protected.

Wireless Disclaimer
The maximum performance for wireless is derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range and coverage. Performance depends on many factors, conditions and variables, including distance from the access point, volume of network traffic, building materials and construction, operating system used, mix of wireless products used, interference and other adverse conditions

Polybrominated Diphenyl Ethers
(Pb)| (Hg)| (Cd)| (Cr6+)| (PBB)| (PBDE)
(PCBA)| 0.1 wt%| ?| ?| ?| ?| ?
(Solder)| ?| ?| ?| ?| ?| ?
(Housing)| ?| ?| ?| ?| ?| ?
(Power Adapter)| 0.1 wt %| ?| ?| ?| ?| ?
(Ethernet Cable)| ?| ?| ?| ?| ?| ?
(Miscellaneous Components)| ?| ?| ?| ?| ?| ?
Note 1: “Exceeding 0.1 wt%” and “exceeding 0.01 wt%” indicate that the percentage content of the restricted substance exceeds the reference percentage valuhe of presence condition.
Note 2: “ ○ ” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence.
Note 3: “–” indicates that the restricted substance corresponds to the exemption.

Korea KC Statement

Singapore Consumer Good Safety Requirements

This product / power adaptor comes with detachable plug / detachable power supply cord set, for Singapore, please use the provided 3-pin plug that complies to SS145 or 2-pin plug that complies to EN50075.

Safety Notices

When using this product, basic precautions should always be followed, including, but not limited to, the following :

WARNING: Do not use this product near water, for example, in a wet basement or near a swimming pool.
WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
WARNING: Do not expose this product to rain or snow. Keep this product away from heat sources, direct sunlight, combustible gas, humidity, water, or other liquids
WARNING: Do not use this product if visible defects are observed or if it has been wet or damaged or modified. Contact the customer service support of Linksys for assistance.
WARNING: Do not disassemble, open, microwave, incinerate, paint, insert foreign objects into this product.
WARNING: Do not expose this product to mechanical shock such as crushing, bending, puncturing, or shredding. Avoid dropping or placing heavy objects on this product.
WARNING: Please read the operating instructions and information on the minimum and maximum operating temperatures supplied with this product.
WARNING: To reduce the risk of injury, close supervision is necessary when this product is used near or by children.
WARNING: This product is intended for indoor use only.
WARNING: Use of this product in a manner not recommended in these instructions may result in a risk of fire or injury to persons.

EU Declaration of Conformity

Manufacturer, Linksys USA, Inc., declare under our sole responsibility that this product is in compliance with Radio Equip-ment Directive
(RED) 2014/53/EU, ROHS Directive 2011/65/ EU, REACH Regulation (EC) 1907/2006, WEEE
Directive 2012/19/EU, Eco-Design Directive 2009/125/EC.
The full text of the EU Declaration of Conformity is available at the following internet address:https://www.linksys.com/DoC/

Operating Frequency and Maximum Transmit Output Power

The operating frequency bands and the maximum transmitted power limit are listed below:
2400 – 2484.5 MHz (20 dBm)
5150 – 5250.0 MHz (23 dBm)
5250 – 5350.0 MHz (23 dBm)
5470 – 5725.0 MHz (30 dBm)

AT| BE| BG| CZ| DK
EE| FR| DE| IE| IT
EL| ES| CY| LV| LT
LU| HU| MT| NL| PL
PT| RO| SI| SK| Fl
SE| UK(NI)| HR| |
 |  |  |  |

Antenna Restrictions
This product is designed for use with the standard, integral or dedicated (external) antenna(s) that is/are shipped together with  the equipment.

Third-Party Software or Firmware The use of software or firmware not supported/provided by Linksys products may result that the equipment is no longer compliant with the regulatory requirements

EU Radiation Exposure Statement

EU Radiation Exposure Statement
This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 35cm between the radiator and your body.

UK Declaration of Conformity

Authorized UK Representative:
Linksys UK Ltd.

Unit 1, Regent Park, Booth Drive, Park Farm South, Wellingborough, Northants, NN8 6GR, United Kingdom

Manufacturer, Linksys USA, Inc., declare under our sole responsibility that this product is in compliance with Radio Equipment Regulations 2017, Electromagnetic Compatibility Regulations 2016, Electrical Equipment (Safety) Regulations 2016, The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012, The Ecodesign for EnergyRelated Products and Energy Information (Amendment) (EU Exit) Regulations 2019.

The full text of the UK Declaration of Conformity is available at the following internet address: http://www.linksys.com/ DoC/

The operating frequency bands and the maximum transmitted power limit are listed below:

• 2400 – 2484.5 MHz (20 dBm)
•  5150 – 5250.0 MHz (23 dBm)
•  5250 – 5350,0 MHz (23 dBm)
• 5470 – 5725,0 MHz (30 dBm)

National Restrictions: This device is restricted to indoor use only when operating in 5150 – 5350 MHz.

UK Radiation Exposure Statement:
This equipment complies with UK radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 35cm between the radiator and your body

WEEE Information

User Information for Consumer Products Covered by EU Directive 2012/19/EU on Waste Electric and Electronic Equipment (WEEE)

This document contains important information for users with regards to the proper disposal and recycling of Linksys home networking products. Consumers are required to comply with this notice for all electronic products bearing the following symbol:

English – Environmental Information for Customers in the European Union

European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/ or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product.

External Power Supply Energy Efficiency Information
The external power supply shipped (either primary or alternate) with this Linksys product is in compliance with Eco-Design Directive 2009/125/EC, commission regulation (EU) 2019/1782 of October 1, 2019.

Primary External Power Supply Information
Manufacturer Name : Kuantech (Cambodia) Co.,Ltd
Manufacturer Address : Phum Chormpul, Khum P’pel, Sork Tramkork, Takeo Province, Kingdom of Cambodia (66KM,National Broad Road)
Model Identifier : KSA-36W-120300D5
Input Voltage (V) : 100-240Vac
Input AC Frequency (Hz) : 50/60Hz +/- 3Hz
Output Voltage (V) : 12.0Vdc
Output Current (A) : 3.0A
Output Power (W) : 36.0W
Average Active Efficiency (%) : 87.4%
Efficiency at Low Load (10%) (%) : 87.49%
No Load Power Consumption (W) : 0.1W
Alternate External Power Supply Information Manufacturer Name APD Group Yang Ming Industrial
Manufacturer Address : No. 10, Maliu Street, HengGang  Subdistrict, Long Gang District, Shen Zhen, P.R.China
Model Identifier : WA-36N12R
Input Voltage (V):  100-240Vac
Input AC Frequency (Hz) : 50/60Hz +/- 3Hz
Output Voltage (V) : 12.0Vdc
Output Current (A) : 3 .0A
Output Power (W) : 36.0W
Average Active Efficiency (%)  : 87.4%
Efficiency at Low Load (10%) (%) : 88.3%
No Load Power Consumption (W) : 0.1W

Visit : linksys.com/support for award- winning 24/7 technical support

LINKSYS, HomeWRK and many product names and logos are trademarks of Linksys Holdings, Inc. and/or its affiliates. Third-party trademarks mentioned are the property of their respective owners. © 2022 Linksys Holdings, Inc. and/or its affiliates. All rights reserved.
LNKPG-00890 Rev. C00

References

• Linksys Official Support - User Guides, Downloads, FAQs
• Linksys | Networking & WiFi Technology
• Linksys Official Support - European Declaration of Conformity

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>