garth Side Burner Injector Bracket Instructions
- June 13, 2024
- garth
Table of Contents
garth Side Burner Injector Bracket
Product Information
The product is equipped with a fascia that can be replaced if needed. The fascia is the front panel of the product that houses the knobs and controls. Replacing the fascia involves following a series of steps to ensure proper installation.
INSTALLATION INSTRUCTION
How to replace the fascia
- Step 1: Take out the bolt from the side burner injector bracket.
- Step 2: Take out the 4 bolts on either side of the side burner shelf, as below.
- Step 3: Loosen the front fixing screws 3mm on either side of the side burner shelf, as the circles show.
- Step 4: Take out the 4 screws as the picture circles on the left side shelf.
- Step 5: Loosen the front fixing screws 3mm on the left side shelf, as the circles show.
- Step 6: Gently draw the fascia out as shown in the following image.
- Step 7 : Take out all the knobs.
- Step 8: Remove all screws from the knob bezel.
- Step 9: Replace with a new fascia.
- Step 10: Reverse steps above to install the parts back. Please pay attention when installing the fascia, so each injector on the manifold aims at the burner inlets.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>