garth Manifold Set Replacement Instructions

June 13, 2024
garth

garth Manifold Set Replacement

Product Information

The manifold set is a crucial component of the product. It is responsible for distributing gas to the burners for ignition and proper functioning of the product. Over time, the manifold may need to be replaced due to wear and tear or damage.

Product Usage Instructions

How to Replace the Manifold Set

  1. Step 1: Take out the bolts as shown in the picture.
  2. Step 2: Take out the bolts as shown in the picture.
  3. Step 3: Gently draw the fascia out as shown below.
  4. Step 4: Take out all the knobs.
  5. Step 5: Remove all screws from the knob bezel.
  6. Step 6: Take out all the knob light connection end.
  7. Step 7: Separate the ignition wire as shown in the following image.
  8. Step 8: Remove the side burner flexible pipe, rear burner flexible pipe, and the regulator as shown in the image.
  9. Step 9:
  10. Replace with a new manifold and conduct a leak test.
  11. Reverse steps above to install the parts back. Please pay attention when installing the fascia, since each injector on the manifold must aim at the burner inlets.

Note: It is important to ensure proper installation of the new manifold and conducting a leak test to ensure safety and optimal performance of the product.

USING INSTRUCTIONS

How to replace the manifold set

Step 1: Take out the bolts as the picture shows.

garth-Manifold-Set-Replacement-FIG-1

Step 2: Take out the bolts as the picture shows.

garth-Manifold-Set-Replacement-FIG-2

Step 3: Gently draw the fascia out as shown below.

garth-Manifold-Set-Replacement-FIG-3

Step 4: Take out all the knobs.

garth-Manifold-Set-Replacement-FIG-4

Step 5: Remove all screws from the knob bezel.

garth-Manifold-Set-Replacement-FIG-5

Step 6: Take out all the knob light connection end.

garth-Manifold-Set-Replacement-FIG-6

Step 7: Separate the ignition wire as shown in the following image.

garth-Manifold-Set-Replacement-FIG-7

Step 8: Remove the side burner flexible pipe, rear burner flexible pipe and the regulator as shown in the image.

garth-Manifold-Set-Replacement-FIG-8

Step 9

  • A. Replace with a new manifold and conduct a leak test.
  • B. Reverse steps above to install the parts back. Please pay attention when installing the fascia, since each injector on the manifold must aim at the burner inlets.

garth-Manifold-Set-Replacement-FIG-9

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals