garth Rear Burner Ignition Wire Installation Guide

garth Rear Burner Ignition Wire Installation Guide

How to replace the rear burner ignition wire

Step 1: Take out the nuts as the picture shows.

Step 2: Draw the rear burner reflector out.

Step 3: Take out the bolt as the picture shows.

Step 4: Gently draw the rear burner ignition wire out.

Step 5: Take out the bolts to get the BBQ frame back cover out

Step 6: Take out the bolts as the picture shows.

Step 7: Take out the fat tray support bracket.

Step 8: Take out the bolts as the picture shows.

Step 9: Loosen the fixing screws 3mm as the picture shows.

Step 10: Loosen the fixing screw 3mm as the picture shows.

Step 11 : Take out the bolts of the side burner injector holder.

Step 12: Take out the bolts as the picture shows.

Step 13: Loosen the fixing screws 3mm as the picture shows.

Step 14: Loosen the fixing screw 3mm as the picture shows.

Step 15: Take out the bolt of the fascia as the picture shows.

Step 16: Gently draw the fascia out as shown in the following image.

Step 17: Separate the rear burner ignition wire as the picture shows.

Step 18:
A. Replace with a new rear burner ignition wire.
B. Reverse steps above to install the parts back. Pay attention when installing the fascia, since each injector on the manifold must aim at the burner inlets.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>