garth Knob Light Line Replacement Instructions
- June 13, 2024
- garth
Table of Contents
garth Knob Light Line Replacement
Product Information
The product is equipped with a knob light line that provides illumination for the knobs. This feature enhances visibility and ease of use, especially in low-light conditions. The knob light line is replaceable, allowing you to maintain optimal functionality of the product.
Product Usage Instructions
- Step 1: Take out the bolts as shown in the picture.
- Step 2: Loosen the fixing screws 3mm as shown in the picture.
- Step 3: Loosen the fixing screw 3mm as shown in the picture.
- Step 4: Take out the bolts of the side burner injector holder.
- Step 5: Take out the bolts as shown in the picture.
- Step 6: Loosen the fixing screws 3mm as shown in the picture.
- Step 7: Loosen the fixing screw 3mm as shown in the picture.
- Step 8: Take out the bolt of the fascia as shown in the picture.
- Step 9: Gently draw the fascia out as shown in the following image.
- Step 10: Take out all the knobs.
- Step 11: Remove all screws from the knob bezel.
- Step 12: Take out all the knob light connection end.
- Step 13: Separate the knob light line as shown in the picture.
- Step 14: Separate the knob light line as shown in the picture.
- Step 15: Replace with a new knob light line.
- Step 16: Reverse the steps above to install the parts back. Pay attention when installing the fascia, ensuring that each injector on the manifold aims at the burner inlets.
Follow these instructions carefully to replace the knob light line and ensure proper installation of the product components.
How to replace the knob light line
- Step 1: Take out the bolts as the picture shows.
- Step 2: Loosen the fixing screws 3mm as the picture shows.
- Step 3: Loosen the fixing screw 3mm as the picture shows.
- Step 4: Take out the bolts of the side burner injector holder.
- Step 5: Take out the bolts as the picture shows.
- Step 6: Loosen the fixing screws 3mm as the picture shows.
- Step 7: Loosen the fixing screw 3mm as the picture shows.
- Step 8: Take out the bolt of the fascia as the picture shows.
- Step 9: Gently draw the fascia out as shown in the following image.
- Step 10: Take out all the knobs.
- Step 11: Remove all screws from the knob bezel.
- Step 12: Take out all the knob light connection end.
- Step 13: Separate the knob light line as the picture shows.
- Step 14: Separate the knob light line as the picture shows.
- Step 15: Replace with a new knob light line.
- Step 16: Reverse steps above to install the parts back. Pay attention when installing the fascia, since each injector on the manifold must aim at the burner inlets.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>