Ameda Breast Pumps and Kits User Manual
- June 13, 2024
- Ameda
Table of Contents
Ameda Breast Pumps and Kits User Manual
Cleaning Instructions for Ameda Breast Pumps and Kits
For Health Care Professions
Below are the CDC and EPA links to recommended disinfectants for SARS-COV-2 which causes COVID-19. CDC Interim Infection Prevention and Control Recommendations for Patients with Suspected or Confirmed Coronavirus Disease 2019 (COVID-19) in Healthcare Settings Learn More
EPA EPA’s Registered Antimicrobial Products for Use Against Novel Coronavirus SARS-CoV-2, the Cause of COVID-19
Learn More
For Mothers at Home
CDC Interim Guidance on Breastfeeding for a Mother Confirmed or Under
Investigation For COVID-19 Learn More
If using a brush, check pump kit parts for cracks, chips, tears or deformation
For At-Home/End Users
After each pumping, turn pump OFF. Wipe with clean, damp cloth.
For Hospital/Rental Stations
Turn pump OFF, Clean between useres, wearing disposable gloves. Use only Ameda approved cleaners such as Metrex CaviWipes or PDI Sani-Cloth AF3
Cleaning the Ameda HygieniKit Milk Collection Kit
- Tubing Adapter
- Silicone Tubing
- Adapter Cap
- Silicone Diagphragm
- Breast Flange
- Valve
- Locking Ring
- Locking Disc
- Bottle
Wash before use if kit is unsterile and after each use.
*Important Do Not Wash (1) Tubing Adapter, (2) Silicone Tubing, and (3) Adapter Cap
Disassemble parts.
Grasp valve by thick sides.
Rinse with cool, clean water.
Wash the parts with warm soapy water under running water. Do not immerse parts
in sink. Do not insert anything into valves while cleaning.
Boil to sanitize
Wash larger pieces in upper rack of dishwasher.
Rinse with warm, clean water.
Air Dry.
*Important Do Not Wash
- Tubing Adapter
- Silicone Tubing
- Adapter Cap
These parts Do Not need to be washed before first use or after each use – milk does not come into contact with these parts while pumping.
CLEANING: Cleaning with warm, soapy water.
After every use, unless otherwise directed by your healthcare provider,
prepare the product for use as follows:
- RINSE any milk from pump parts with cool water.
- Hand WASH with warm, soapy water, the flange(s), back-flow protector(s), valve(s) and (if applies) bottle(s), locking ring(s) and locking disc(s). Wash valve(s) and back-flow protector(s) silicone gently*.
- RINSE with warm, clean water the flange(s), back-flow protector(s), valve(s) and (if applies) bottle(s), locking ring(s) and locking disc(s).
- Air DRY each part on a clean surface.
*Ameda does not recommend inserting anything into the valves and backflow protectors for cleaning but if you want to use a brush or sanitizing steam bags, then it is very important to check for cracks, chips. tears or deformation before and after use.
ALWAYS wash hands well with soap and water.
Consult Instructions For Use Ameda Breast Pumps and HygieniKit/Manual Pump
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>