EUROfase LIGHTING 38152 30 Inch Wide LED Pendant Light Instruction Manual
- June 13, 2024
- EUROfase LIGHTING
Table of Contents
EUROfase LIGHTING 38152 30 Inch Wide LED Pendant Light
Product Information
Product Model: 38152
Components
- a – 1pc
- b – 2pcs
- c – 1pc
- d – 2pcs
Dimensions
- a – 18”
- b – 25.5”
- c – 19”
- d – Not specified
Product Usage Instructions
- Start by assembling the components:
- Attach component “a” to the designated area.
- Attach component “b” to the designated area, using two pieces.
- Attach component “c” to the designated area.
- Attach two pieces of component “d” to the designated area.
- Connect the wires from the junction box and driver:
- Connect the black wire (L) from the junction box to component “B”.
- Connect the white wire (N) from the junction box to component “C”.
- Connect the green wire/bare copper (G) from the junction box to component “D”.
- Connect the red wire (LED+) from the driver to component “E”.
- Connect the black wire (LED-) from the driver to component “F”.
- Connect the green wire/bare copper from the mounting plate to component “G”.
- Connect three wire connectors to components “H”.
- Connect the red wire (LED+) from the fixture to component “I”.
- Connect the black wire (LED-) from the fixture to component “J”.
Thank You
You’ve just purchased a lighting product designed and built to provide you
with years of enjoyment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder.
PARTS
- A- Outlet Box screw × 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Red wire (LED+) from driver
- F- Black wire (LED-) from driver
- G- Green wire/Bare copper from mounting plate
- H- Wire connector x 3
- I- Red wire (LED+) from fixture
- J- Black wire (LED-) from fixture
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>