EUROfase LIGHTING 38158 Ombra LED Oval Chandelier Instruction Manual
- June 13, 2024
- EUROfase LIGHTING
Table of Contents
EUROfase LIGHTING 38158 Ombra LED Oval Chandelier
Product Usage Instructions
- Begin by gathering the necessary components:
- A-Outlet Box screw x 2
- B-Black wire (L) from junction box
- C-White wire (N) from junction box
- D-Green wire/Bare copper (G) from junction box
- E-Red wire (LED+) from driver
- F-Black wire (LED-) from driver
- G-Green wire/Bare copper from mounting plate
- H-Wire connector x 3
- I-Red wire (LED+) from fixture
- J-Black wire (LED-) from fixture
- Identify the outlet box and secure the fixture using the A-Outlet Box screws.
- Connect the wires as follows:
- Connect the B-Black wire (L) from the junction box to the corresponding black wire on the fixture using a wire connector.
- Connect the C-White wire (N) from the junction box to thecorresponding white wire on the fixture using a wire connector.
- Connect the D-Green wire/Bare copper (G) from the junction box to the G-Green wire/Bare copper on the mounting plate.
- Connect the E-Red wire (LED+) from the driver to the I-Red wire (LED+) from the fixture using a wire connector.
- Connect the F-Black wire (LED-) from the driver to the J-Black wire (LED-) from the fixture using a wire connector.
- Make sure all connections are secure and properly insulated.
- Once all the connections are made, turn on the power and test the dimming functionality of the LED light fixture.
Thank You
You’ve just purchased a lighting product designed and built to provide you with years of enjoyment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly
Tools Required For Assembly (not included)
- Flathead screwdriver,
- Phillips screwdriver,
- Pliers,
- Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
Installation Instructions
- A- Outlet Box screw × 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Red wire (LED+) from driver
- F- Black wire (LED-) from driver
- G- Green wire/Bare copper from mounting plate
- H- Wire connector × 3
- I- Red wire (LED+) from fixture
- J- Black wire (LED-) from fixture
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>