EUROfase LIGHTING 34162 Guelph Chrome Bath Bar Instruction Manual
- June 12, 2024
- EUROfase LIGHTING
Table of Contents
EUROfase LIGHTING 34162 Guelph Chrome Bath Bar
Product Information
- Product Model: 34162
- Product Type: Lighting
- Power: 5 x 6W MAX, LED, 120V, 60Hz (Dimmable LED Included)
Product Usage Instructions
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Helpful Tools (not included):
- Wire strippers
- Ladder
- Follow the steps below for installation:
- Securely attach the product to the outlet box using the provided outlet box screws (A).
- Connect the black wire (L) from the junction box (B) to the black wire (L) from the fixture (E) using a wire connector (H).
- Connect the white wire (N) from the junction box (C) to the white wire (N) from the fixture (F) using a wire connector (H).
- If applicable, connect the green wire/bare copper (G) from the junction box (D) to the green wire/bare copper from the fixture (G) using a wire connector (H).
- Securely tighten all wire connectors (H) to ensure proper electrical connections.
- Use electrical tape to insulate any exposed wire connections for safety.
- Follow any additional instructions provided in the user manual for dimming or adjusting the lighting.
Please refer to the manual for further instructions and safety information.
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
SPECIFICATION
5 X 6W MAX,LED,120V,60Hz (Dimmable LED Included)
INSTALLATION INSTRUCTION
- A-Outlet Box screw x 2
- B-Black wire(L) from junction box
- C-White wire(N) from junction box
- D-Green wire/Bare copper (G) from junction box
- E-Black wire (L) from fixture
- F-White wire (N) from fixture
- G-Green wire/Bare copper from fixture
- H-Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>