allen roth FSI 1201A BGLD Kirby Matte Black Steel Single Curtain Rod with Finials Instruction Manual
- October 31, 2023
- Allen+Roth
Table of Contents
Allen Roth FSI 1201A BGLD Kirby Matte Black Steel Single Curtain Rod with
Finials
Product Information
- Product Name : DRAPERY ROD SET
- Trademark: ALLEN+ROTH
- Trademark Owner: LF, LLC
- Estimated Assembly Time: 30 minutes
Product Usage Instructions
- Make sure to use a level (not included) during installation.
- If possible, place the curtain hooks on the rod ready for hanging.
- Use the provided screws and anchor plugs if necessary.
- Securely lock the rod in place by reattaching the end cap and tightening all screws.
- Hang the assembled rod on the brackets.
Thank you for purchasing this allen + Roth product. We’ve created these easy- to-follow instructions to ensure you spend your time enjoying the product instead of putting it together. But, if you need more information than what is provided here, please visit Lowes.com, search for the item number, and refer to the Guides & Documents tab on the product’s page. If the item is no longer for sale, or if you have any questions or problems, please call our customer service department at 866-439-9800, 8 a.m. – 8 p.m., EST, Monday – Sunday. You can also contact us at partsplus@lowes.com.
The image is for example only. The appearance of the actual product may vary
PREPARATION
Before beginning assembly of the product, make sure all parts are present.
Compare parts with the package contents list and hardware contents list. If
any part is missing or damaged, do not attempt to assemble the product
Estimated Assembly Time: 30 minutes
TOOLS REQUIRED (NOT INCLUDED)
PACKAGE CONTENTS
HARDWARE CONTENTS
INSTALLATION OVERVIEW
-
Using the bracket as a guide, adjust to the desired height and mark the location on the wall for mounting screws.
-
Remove the bracket from the wall. Drill pilot hole using 3/16 in. bit (not included) and insert wall anchors NOTE : Anchors are not needed for all installation types.
-
Attach the bracket to the wall using the screws provided NOTE : Repeat steps 1 to 3 for additional brackets. Use level (not included) if necessary.
-
Extend the telescopic rod slightly. Remove the final from the smaller diameter rod section.
-
Slide additional rod over smaller diameter rod NOTE : At this point, you should have a complete telescopic rod with 2 large diameter rods connected with 1 smaller diameter rod section in the middle.
NOTE : At this point, you should have a complete telescopic rod with 2 large diameter rods connected with 1 smaller diameter rod section in the middle. -
Reattach the finial and tighten the set screws on the brackets to lock the rod in place.
CARE AND MAINTENANCE
- Clean with a soft cloth.
- Do not use abrasive cleaning agents, solvents, or polishes as they may damage the finish.
TROUBLESHOOTING
FEELING CONFIDENT?
START YOUR NEXT PROJECT
Visit lowes.com for more information
ALLEN+ROTH and logo design are trademarks or registered trademarks of LF, LLC.
All rights reserved
Printed in China