pontec PondoStar LED RGB Set Instruction Manual

pontec PondoStar LED RGB Set

Product Information

• Product Name: PondoStar LED RGB Set 3

• Manufacturer: Water Gardening Direct

• Scope of Delivery:

  • 3 LED spotlights
  • 1 receiver
  • 1 transformer
  • 1 remote control

• Technical Specifications:

  • Rated voltage: 230V AC / 50Hz

  • Output voltage: 12V AC

  • Max. power output: 12VA

  • Protection type: IP44 (dust and splash water protected)

  • Max. immersion depth: 1m

  • Operation at water temperature: +4°C to +35°C

  • Length of the connection cable to receiver between the
    spotlights: 3m

  • Dimensions: 125mm (H)

  • Max. power consumption: 5W

  • Type of battery: CR2025 button cell

  • Weight: 0.75kg

Product Usage Instructions

Installation and Connection:

1. Ensure that the power supply is uninterrupted.
2. Connect the transformer to the power supply.
3. Connect the receiver to the transformer.
4. Place the LED spotlights in the desired locations.

Commissioning/Start-up:

1. Turn on the spotlight using button 1 on the remote control.
2. Select an effect using button 2. Adjust the effect speed using button 4.
3. Select a spotlight color using button 3. Adjust the brightness using button 4.

Remedy of Faults:

Malfunction: Spotlights do not light up

• Check the power supply.
• Replace the transformer if necessary.
• Clean the spotlights if they are soiled.
• Replace the battery in the remote control if it is weak.

Illuminating power decreasing: Spotlights can be switched on/off, but light effects cannot be changed

• Check the power supply.
• Replace the transformer if necessary.
• Clean the spotlights if they are soiled.
• Replace the battery in the remote control if it is weak.

Maintenance and Cleaning:

Changing the Battery:

1. Open the battery compartment.
2. Pull out the old battery and replace it with a new one.

Disposal:

Dispose of the product according to local regulations. Do not dispose of in regular household waste.

Symbols on the Unit:

• Complete protection against contact, dust-tight, protected from continuous immersion in water to a depth of 1m.
• Dust protected. Splash water protected.
• Protection class III – Device operates with safety low voltage or extra-low voltage.
• Safety transformer.
• LED class 1 – Do not look directly into the beam source. Protect from direct sunlight.

Operating Instructions

• This unit can be used by children aged 8  and above and by per-sons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they are supervised or have been instructed on how to use the unit in a safe way and they understand the hazards involved.
• Do not allow children to play with the unit.
• Only allow children to carry out cleaning and user maintenance un-der supervision.
• Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
• Only connect the unit if the electrical data of the unit and the power supply correspond. The unit data is to be found on the unit type plate, on the packaging or in this manual.
• Possible death or severe injury from electrocution! Before reaching into the water, disconnect all electrical units in the water from the mains.
• Do not use the unit if electrical cables or housings are damaged.
• A damaged connection cable cannot be replaced. Dispose of the unit.

Safety information

Correct electrical installation

• Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
• A person is regarded as a qualified electrician if, due to his/her vocational education, knowledge and experience, he or she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the recognition of possible hazards and the adherence to the pertinent regional and national standards, rules and regu-lations.
• Only connect the unit if the electrical data of the unit and the power supply correspond.
• For your own safety, please consult a qualified electrician.
• Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).
• Install the transformer at a minimum safety distance of 2 m from the water.
• Protect the plug connection from moisture.
• Only connect the unit to a correctly fitted socket.

Safe operation

• Never carry or pull the unit by the electrical cable.
• Route cables such that they are protected from damage and do not present a tripping hazard.
• Only open the unit housing or its attendant components if this is explicitly specified in the operating instructions.
• Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an authorised customer service point or, if in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical changes to the unit.
• Only operate the unit with the supplied transformer.
• The power pack or transformer and plug connections are only protected from rain and splash water, they are not waterproof. Ensure that they are never placed in water.

Information about these operating instructions

• You made a good choice with the purchase of this product PondoStar LED RGB Set 3.
• Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit. Ensure that all work on and with this unit is only carried out in accordance with these instructions.
• Adhere to the safety information for the correct and safe use of the unit.
• Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new owner.

Warnings used in these instructions
The warning information is categorised by signal words, which indicate the extent of the hazard.

WARNING
Indicates a possibly dangerous situation, which could lead to death or severe injuries, if not avoided.

NOTE
Indicates a possibly dangerous situation, which could lead to damage to property or the environment, if not avoided.

Cross-references used in these instructions

A reference to a figure, e.g. figure A.
Reference to another section.

Intended use

Only use the product described in this manual as follows:

• For use in water fountain systems and ponds.
• For use above and under water.
• Use for private purposes only.
• Operate in accordance with instructions. (→ Technical data)

The following restrictions apply to the unit:

• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.

Scope of delivery

Installation and connection

Commissioning/start-up

Possible death or severe injury from hazardous electrical voltage!

• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.

NOTE
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.

• Do not connect the unit to a dimmable power supply.
• Switching on : Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
• Switching off: Disconnect the transformer power plug.

Operation

The spotlight is operated using the buttons on the remote control:

adjust the effect speed.
3| Select the spotlight colour. After selecting a colour, buttons 4 can be used to adjust the brightness.
4| Setting the effect brightness or speed.

Remedy of faults

Maintenance and cleaning

WARNING
Possible death or severe injury from hazardous electrical voltage!

• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.

If necessary, clean the unit with clear water using a soft brush.

• Ensure that no moisture can enter the unit.

Changing the battery
How to proceed:

• Open the battery compartment.
• Pull the battery from its holder and replace it.
• Pay attention to the polarity of the batteries.
• Push the battery holder into the remote control

Wear parts

• Battery

Disposal

Do not dispose of this unit with domestic waste.
Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided for this purpose

Technical data

Symbols on the unit

Guarantee conditions

PfG grants a 2 year guarantee from the date of sale on proven material and manufacturing faults. Wear parts such as bulbs etc. are exempted from the guarantee. Prerequisite for our guarantee is the presentation of the purchase receipt. Our guarantee will become null and void if the unit is misused, electrically or mechanically damaged by inappropriate use and improper repair by non-authorised workshops. Repairs are reserved for workshops authorised by PfG or by PfG itself. In the case of warranty claims, please return the defective unit or part freight paid to PfG together with a description of the fault and the purchase receipt. PfG reserves the right to invoice repair costs. PfG is not liable for transport damage. Any damage must be claimed against the carrier. Further claims of whatever type, especially consequential damage, are excluded. This guarantee does not affect the final customer’s claims against the dealer.

PfG GmbH
Tecklenburger Straße 161 D – 48477 Hörstel Germany
www.pontec.com

References

• Pond Equipment and Pond Filtration Equipment - Water Gardening Direct

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>