Lilitab Pro Floor Mount User Guide
- September 13, 2024
- lilitab
Table of Contents
**Lilitab Pro Floor Mount User Guide
**
Shipment Content: **
**
1 x Floor Basic Mount
1 x Floor Base
1 x Base Housing
4 x Base Screws
1 x Phillips Screwdriver
1 x Key
Quick Setup:
- Make sure both cables are fed through the rear notch of the post. Fasten the post to the base plate with provided screws(shorter) and screwdriver, **aligning with rear openings.
**
-
Slide the base housing cover down and position the cables underneath the cable cut out through the base housing towards the back.
-
Fasten the housing cover to the base using the 2 remaining screws(longer) and then attach the base housing cover by sliding it into place.
-
To open the faceplate, squeeze & hold the 2 buttons at the back of the faceplate while sliding the bezel upwards (opposite to the RFID reader).
-
Connect the iPad to the charging cable and place it in the **Lilitab case.
**
-
Connect the NFC reader to the USB charging cable, switch the toggle to Bluetooth and place it in the Lilitab case.
-
Secure the iPad into the case by sliding in the faceplate towards the NFC reader and clicking it into place.
-
Please follow the NFC reader connection steps from your registration software provider. Do not add Bluetooth device right away via iPad settings.
-
Place the case horizontally onto the Lilitab stand and lock it in place using the provided key. **PLEASE BE CAREFUL NOT TO MISPLACE THE KEY. WITHOUT THE KEY, YOU WON’T BE ABLE TO OPEN THE CASE
**
- Adjust the viewing position by tilting the iPad up and down. Use the small Hex Key to adjust the tilt.
- Once the iPad is set up and attached to the Lilitab floor stand, your device will be ready for use.
Troubleshooting:
What if…
… my NFC reader does not light up?|
- Inspect the cable at both the power cable and reader ends.
- Rotate the iPad’s face plate to see if it charges in various orientations.
- Ensure that the reader is powered on.
---|---
… my iPad is not charging?|
- Inspect the cable at both the power cable and iPad ends.
- Rotate the iPad’s face plate to see if it charges in various orientations.
… the viewing position won’t remain fixed?| Use the supplied Allen wrench to adjust the viewing angle according to your preference.
Setup Video Guide: Scan this QR code with your phone camera for
video.
Contact our Support Team:
www.choose2rent.com/help
+1 800-622-6484
Ext. 3 (USA)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>