Velocity Boiler Phantom II Heat Only Instruction Manual
- June 12, 2024
- Velocity Boiler
Table of Contents
**Velocity Boiler Phantom II Heat Only
**
WARNING
Asphyxiation Hazard. Fire Hazard. Explosion Hazard.
This boiler must be installed, serviced or repaired by a qualified installer,
service agency or gas supplier.
Improper installation, adjustment, alteration, service or maintenance can
cause severe personal injury, death, or substantial property damage. Read and
understand these instructions and entire boiler manual before attempting to
install boiler and header. Up to date boiler manual is posted on
manufacturer’s website.
Instructions apply to the following accessory:
| Accessory Part | Description |
|---|---|
| 111884-01 | Primary/Secondary Header, Heat Only |
Included with this accessory:
- Header
- Instructions
- Gaskets
Recommended tools:
- Pipe wrench
- Adjustable wrenches
- 5/8 in. wrench for pump flange
To install Header, perform the following steps:
- Assemble manifold as shown in Figure 1.
- Follow piping section of Installation, Operating and Service Instructions to connect to system piping. 1-1/4 in. connections can be sweat or press.
- Follow Start-Up and Checkout in Installation,
Operating and Service Instructions.
WARNING
Burn Hazard.
Safety relief valve discharge piping must be piped near floor to eliminate
potential of severe burns. Do not pipe in any shut-off valves between:
- Safety relief valve and boiler
- Safety relief valve and discharge.
Union may be installed in safety relief valve piping.
WARNING
Burn Hazard.
Excessive heat during soldering could damage gaskets. All piping should be
checked for leaks after assembly. Failure to do so could result in personal
injury or substantial property damage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>