OWON PIR 323-Z-TY Tuya ZigBee Multi-Sensor User Guide

OWON PIR 323-Z-TY Tuya ZigBee Multi-Sensor User Guide

Safety Notice

WARNING: Failure to follow these safety notices could result in fire,electric shock, injuries, or other damage to the your property. Please read all the safety notices below before using the sensor.

• Avoid high humidity or extreme temperatures.
• Avoid long exposure to direct sunlight or strong ultraviolet light.
• Do not drop or expose the unit to intense vibration.
• Do not disassemble or try to repair the unit yourself.
• Do not expose the unit or its accessories to flammable liquids, gases or other explosives.

Technical Specifications

Welcome

PIR323-TY is a Tuya Zigbee multi-sensor with built-in temperature, humidity sensor and PIR sensor which can be equipped with Tuya gateway and Tuya APP .
This guide will provide you with an overview of the product and help you get through the initial setup.

Features:

• ZigBee 3.0
• PIR motion detector
•  Enviromental temperature and humidity measuring
• Low-power consumption

Installation

You can mount the multi-sensor to the wall, ceiling or keep your multi-sensor on a bookshelf or table.

• Please ensure that the surface is clean and secure.
• You can peel off the tape on the back or lock it with screws.

1.  Avoid mounting the Multi-sensor close to pets, air conditioners, heaters, sunshine or places where the temperature varies.

2. You need to pay attention to the distance and range of the sensor when installing.
   

Get to Know Your Device

LED Indicator

LED Status What   it  means Green light flashes once
Motion detected Green light keeps flashing Emnotderen

Reset Button

Reset: Press and hold the reset button for 5 seconds, green light will start flashing, and then the device will automatically enter the network configuration mode.

Configure Network

4.1 To get started, you will need:

• A Tuya Zigbee Gateway
• A mobile phone with the specified APP installed.

4.2 Adding to the gateway’s network

1. Set your gateway to permit joining (see your gateway’s manual).
2. Ensure that the sensor is within the signal range of the gateway, and install the sensor with two pcs AAA battery, then press reset button for 5 seconds, and green light will start flashing which means the device will automatically enter the network configuration mode.
3. Wait for the sensor to be automatically added to the gateway. If the green light stops blinking, the gateway is successfully added.

NOTE: If the adding is failed, please reset the sensor and try again.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>