VIDEX VLF-H065A LED Rechargeable Headlamp User Manual

: June 12, 2024
: VIDEX

Table of Contents

TECHNICAL PARAMETERS
PRODUCT OVERVIEW
TECHNICAL PARAMETERS
MAIN FEATURES
INCLUDED
LIGHTING MODES
OPERATING INSTRUCTION
BATTERY STATUS INDICATION
CHARGING
BATTERY REPLACEMENT
MAINTENANCE AND SAFETY INSTRUCTIONS
WARRANTY
ENVIRONMENTAL PROTECTION
CUSTOMERS SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VIDEX VLF-H065A LED Rechargeable Headlamp

TECHNICAL PARAMETERS

| |

TURBO*

| HIGH| MIDDLE| LOW| MOON| sos
---|---|---|---|---|---|---|---
1| | 1200Lm| 700Lm| 400Lm| 130Lm| 25Lm|

700Lm

2

| |

1h 20min

| 1h 30min| 3h| 11h| 58h|

2h 30min

3

| | 100m| 70m| 55m| 30m| 13m| 70m
4| | 2400cd| 1300cd| 770cd| 240cd| 45cd|

1300cd

5

| | 5000K
6| |

LUMINUS SST4010W

7

| | Li-ion18650 2200mAh
8| |

Type-C, 5V 2A

9

| | 3,5 h
10| |

IP68

11

| | 2m
12| |

90x26x35mm

13

| | 116 g(without battery)

PRODUCT OVERVIEW

You can check the battery charge when it is on.

USB Type-C flashlight charging connector

TECHNICAL PARAMETERS

Output.
Runtime.
Distance.
Intensity.
Correlated color temperature.
LED type.
Compatible battery.
Charging port type, voltage and current.
Charging time.
Dust and moisture protection level.
Impact resistance.
Product sizes.
Product weight (without battery).
Color: black.
Optical system type: optical lens
Materials: Aviation anodized aluminum, tempered glass.

Note: Runtime, Distance, Intensity and Charging time results tested with a stock battery Videx 18650 2200mAh. The above mentioned parameters may vary between environments and actual batteries used.

*The Turbo mode runtime is the accumulated time, including reduced output levels with the overheat protection enabled.

MAIN FEATURES

Maximum brightness 1200 lumens in a compact body;
Frosted optical lens for optimal balance between low and high beam;
Water resistance IP68 (short-term immersion under water to a depth of 2 meters);
Side magnet for various secondary mounting ways;
Both fast release holder and standard holder included;
Compatible with primary 2xCR123A batteries.

INCLUDED

Headlamp VLF- H065A;
Li-ion battery Videx 18650 2200mAh;
Charging cable;
Headband;
Quick release holder;
Standard holder;
Spare O-rings; 8. User’s manual.

LIGHTING MODES

Turbo – maximum brightness
High – high brightness
Middle – medium brightness
Low – low brightness
Moon – minimum brightness
SOS – emergency signal

OPERATING INSTRUCTION

ON/OFF – press and hold the button for 0.5 seconds to turn on/off the light;
Modes selection – when the light is switched on, shortly press the button to switch between modes cyclically.
SOS mode – press and hold the button for 3 seconds. Short press again to exit SOS mode.
Lock/Unlock – with the light switched off , double press the button continuously within 0.5 seconds to lock the flashlight. The flash light will respond by appropriate double flicker. Double press again to unlock.

The headlamp automatically memorizes the last selected lighting mode (except the SOS mode) and applies it next time when turned on.

BATTERY STATUS INDICATION

With the light switched off , shortly press the button to see the battery status. The indication will last for 3 seconds. The battery status is also continuously displayed when the light is turned on.

Continuous green light – 100-80% charge;
Flashing green light – 79-50% charge;
Continuous red light – 49-25% charge;
Flashing red light – critical charge 24-1%.

CHARGING

Plug the USB-A socket of the charging cable into electrical outlet. Switch off the light, unscrew the protective cover counterclockwise and connect the charging cable to the headlamp port.
ATTENTION: primary CR123A batteries cannot be charged. When charging, the indicator glows red. When fully charged, the indicator glows green.
After a full charge, unplug the charging cable and screw the protective cover all the way in to prevent water and dust from entering the headlamp body.
© The original rechargeable batteries are supplied charged and can be used immediately after purchase, however it is recommended that the battery be fully charged before first use. The battery needs to be charged in time before it is completely discharged. During long periods of storage, it is recommended to keep the battery charging level at about half capacity to extend its service life.

BATTERY REPLACEMENT

a) Unscrew the battery cover counterclockwise;
b) Insert the battery according to the diagram shown on the outside of the headlamps body;
c) Screw the battery cover all the way in and test the device

MAINTENANCE AND SAFETY INSTRUCTIONS

For long-term storage, it is necessary to remove the batteries from the device.
It is recommended to regularly lubricate the rubber seals and threaded parts of the headlamp to prevent premature wear and ensure the waterproof housing. If the rubber rings are damaged, they must be replaced.
Lock the headlamp to avoid accidental activation during carrying and storage;
ATTENTION. Avoid direct light into eyes as it may cause the eyes damage.
The headlamp can accumulate a signified cant amount of heat when used for a long time, which can cause the body to become hot. Therefore, be careful to avoid burns.
It is forbidden to shine the headlamp in a critical proximity to easily flammable substances in order to avoid fi re.
Do not use batteries other than those specified in the technical specified cations.
Do not disassemble the headlamp head as this may compromise performance and void the warranty.
Do not charge the headlamp with CR123A batteries inside.
Keep out of the reach of children.

WARRANTY

The warranty for the headlamp is 3 years, for the battery – 1 year.

The warranty does not cover accessories. The LED source inside the headlamp is not replaceable. If the LED fails, the whole headlamp should be replaced. During the warranty period, a faulty headlamp and battery can exchanged or returned with the prove of purchase and all accessories saved.

The following does not apply with the scope of limited warranty:

Misuse the product and cause the products integral components damage;
Unauthorized disassemble or the presence of deep mechanical damage to the product;
Damage due to force majeure.

ENVIRONMENTAL PROTECTION

Pursuant to the provisions of the WEEE Act, it is forbidden to put waste equipment marked with the symbol of a crossed bin together with other waste. The user, wishing to get rid of electronic and electrical equipment, is obliged to return it to a waste equipment collection point. There are no hazardous components in the equipment that have a particularly negative impact on the environment and human health.
The producer shall not be responsible for any damage resulting from the failure to follow above instructions. The producer reserves the right to make updates of this user’s manual.