ATEL FJ1510MA GPS Tracker User Manual

FJ1510M‐UserMannual

Plug in the test wire

Plugthe test wire of TM97 into the device as follows:

1. Start the device
   To power the device, a 12V adapter is plugged directly into the DC female head of the test line.
   The green light of the device will flash to represent the power on.

2. SIM card (4FF micro SIM size) installation
   a. Open the top plastic，Then unscrew the three screws and take the machine out and turn it around.
   as shown below ：

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to  comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause  harmful interference to radio or television reception, which can be determined by turning the equipment off  and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co‐located or operating in conjunction with any other  antenna or transmitter.
ISED Warning statements
This device complies with Canada’s licence-exempt RSSs. Operation is subject to the following
two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesiredoperation of the device.

This Class B digital apparatus complies with Canadian ICES-003.
Cetappareilnumeriquede la classe B estconforme a la norme NMB-003 du Canada.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>