BROWIN Distiller with Cooler and Clarifier 30L User Manual
- June 12, 2024
- BROWIN
Table of Contents
BROWIN Distiller with Cooler and Clarifier 30L User Manual
This manual is part of the product and should be stored in a manner that allows to familiarize with its content in the future. It contains important information about the product and its use.
WARNING!
The appliance can be used by adults only. Never leave the running machine
unattended. Make sure that the location of the device storage is adequately
protected against access by children and unauthorized persons.
The manufacturer is not liable for any damages resulting from use of the
appliance contrary to its intended use or inappropriate handling.
The manufacturer reserves itself the right to modify the product at any time,
without prior notice, in order to adapt to legal provisions, standards,
directives, or due to construction, trade, aesthetic or other reasons.
The device is intended for home use.
Each country has its own regulations, inter alia, on the principles of manufacturing and bottling spirits, and marketing them, as well as sanctions for non-compliance with these regulations. In the Republic of Poland, the Act of 18th October 2006 on manufacturing spirits and their registration and protection of geographical indications of spirit drinks is in force (Dz.U. [Journal of Laws] of 2006, No. 208, item 1539 as amended).
[Limited liability company limited
partnership] shall not be liable for using its products by the user contrary
to the law.
SET INCLUDES
- The 30 l (18 l) container
- Cover with silicone seal
- Cooler with a clarifier
- Hoses to connect the distiller with a plastic connector
- Clarifier valve
- Analogue thermometer for the container lid
- Electronic thermometer to the clarifier
- Instruction manual
TECHNICAL DATA
CONTAINER 30 L (18 L)
- Purpose: kitchen utensil for domestic use
- Material: stainless steel
- Heat source: electric stove, induction, ceramic, gas, spiral
- Maximum filling: max. to the capacity of 25 l (14 l)
- The minimum permissible filling: 5 l for the purposes of distillation
DISTILLATION APPARATUS: cooler with the clarifier made of stainless steel.
THERMOMETERS
- A thermometer for measuring the temperature of vapours inside the pot
- Tolerance: +/-1 C
- Analogue thermometer dedicated to distillation.This thermometer is used for approximate temperature reading, demonstratively.
- A thermometer for measuring the temperature of vapours in the clarifier
- Stainless steel probe with a length of 140 mm
- Temperature range: -50o C to +300o C (-58o F to 572o F)
- Tolerance: +/-1 o C
- Accuracy: 0.1o C
- The button oC/o F – used to turn the thermometer or change temperature units to Celsius or Fahrenheit.
- ON/OFF button
- HOLD button (stops measurement results on the display)
- MAX / MIN button (Displays the stored maximum and minimum measurement results)
- Batteries: 1x LR44 (included)
- This thermometer is used for controlling the proper distillation temperature.
INSTALLATION OF DISTILLATION KIT
(Before the first use, wash the pot thoroughly with dish washing liquid and
dry. Do not use the so-called steel wool or scouring powders)
- Install the analogue thermometer in the container lid (in smaller opening). Locating the gasket properly on the top and bottom of the cover, and tightening the screw from below.
- Attach coolers to the lid (at the centre hole), placing the seal from the bottom of the cover by tightening the screw so that the cooler was stable.
- Stretch Teflon tape (not included) on the thread of the clarifier, screw the ball valve on it. After screwing make sure that it is closed.
- Place the container on the heating station, pour the liquid in an amount of not more than 25 l (14 l). Place the lid to allow the outflow of distillate, combine everything with staples.
- Install hoses to the radiator nozzles. To the lower nozzle, the feed tube and to the upper discharge, cooling water.
- Place the electronic thermometer in the clarifier.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>