Extron UCS 900 Series USB 5 Gbps Extenders User Guide
- June 13, 2024
- Extron
Table of Contents
Extron UCS 900 Series USB 5 Gbps Extenders User Guide
NOTE:
- This product supports USB data ONLY. DisplayPort Alt Mode and Power Delivery are NOT supported.
- The use of a USB 2.0 hub on the UCS FR 902 is not recommended. If a hub is needed in the system, Extron recommends the use of a USB 3.2 hub. Please contact your Extron AE for more details.
Installation
ATTENTION: Installation and service must be performed by authorized personnel only.
Mounting
The UCS FT 901 and UCS FR 902 can be rack mounted, furniture mounted, or placed on a tabletop with the provided rubber feet. For ZipClip mounting instructions, see the UCS FT 901 and UCS FR 902 User Guide at www.extron.com.
Connecting Cables
WARNING: Fiber optic connectors emit continuous invisible light, which may be harmful to the eyes; use with caution. Do not look into the fiber optic cable connectors or into the fiber optic cables themselves. Plug the attached dust caps into the optical transceivers when the fiber cable is unplugged.
The illustration below shows connections for the UCS FT 901 and UCS FR 902.
Connecting Power
Power off all devices that will be directly connected to the receiver.
Wire the 24 W power supply (see previous page, 1) to the transmitter 2-pole
captive screw connector (3), and the 6 W power supply (2) to the receiver (see
the illustration at right for wiring instructions).
NOTE: The UCS FT 901 (transmitter) can also be powered by the Host device,
without the need for the external power supply.
Once a unit receives power, the front panel Power LED (see the unit
illustrations on the right, A) lights.
Connecting the Host (Transmitter)
-
Connect a USB Type A-to-C (or Type C-to-C) cable from the
Host device to the transmitter Host port (4). The Host LED on the transmitter (B) lights as communication between the
transmitter and host device is established.
NOTE: The transmitter is compatible with USB 3.2 host ports ONLY. USB 3.2 ports are either blue Type A, Type C, or labeled with a SuperSpeed trident logo (see below). -
Connect a multimode fiber optic cable from the output port of the transmitter to the input port of the receiver (5).
-
Once the cable is connected to both the transmitter and receiver, the front panel Link LEDs light steadily (C).
-
Mount the devices, if appropriate.
-
Power on the host device. The transmitter (UCS FT 901) Host LED (B) lights when the computer recognizes the transmitter.
Connecting the Devices (Receiver)
Connect up to two USB peripheral devices to the receiver devices ports (6).
The order of connection does not matter.
The UCS FR 902 (receiver) supplies up to 5 V, 1.5 A to each connected
peripheral device. The system is now ready to operate.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the Extron Safety and Regulatory Compliance Guide on the Extron website.
© 2021 Extron — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
68-3621-50 Rev. B 04 21
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805,
800.633.9876
References
- Manual-Hub.com - Free PDF manuals!
- Extron - The AV Technology Leader
- Extron Electronics
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>