Penn State Industries PKMBL125 Big Grabber Closed End Mandrel Instructions
- June 12, 2024
- Penn State Industries
Table of Contents
Penn State Industries PKMBL125 Big Grabber Closed End Mandrel
Product Information
| ID Number | PKMBL125 |
|---|---|
| Number of Parts | 1 |
| Type | Internal Bushing |
| Thru Hole | M6 x 1.0 Female Threaded Blind Hole |
| Notes | This part threads onto the end of the Big Grabber Mandrel for |
stabilizing the end of closed end projects with 12.5mm tubes.
Product Usage Instructions
- Identify the Big Grabber Mandrel and ensure it is properly installed for use.
- Take the Internal Bushing and align it with the end of the Big Grabber Mandrel.
- Gently thread the Internal Bushing onto the end of the Big Grabber Mandrel in a clockwise direction.
- Tighten the Internal Bushing until it is securely attached to the Big Grabber Mandrel.
- Proceed with your closed end project using 12.5mm tubes.
- After completing your project, carefully remove the Internal Bushing by turning it counterclockwise.
PICTURE IS AN APPROXIMATE REPRESENTATION. NOT TO EXACT SCALE OR PROPORTION. ALL MEASUREMENTS IN INCHES. BUSHING DIAMETERS (TOP ROW) ARE OPTIMAL AND SHOULD VARY BY NO MORE THAN .002″ WHEN NEW.
ID NUMBER PKNICK-BU NUMBER OF PARTS 2
THRU HOLE STANDARD (0.248′)
TYPE: BUSHING
NOTE : TIP AND ►
CAP SAME DIMENSIONS
PART NAME AND (QUANTITY)SECTION ►
CAP/TIP (2)
BARREL EXTENSION
ASSOCIATEDPKRYL(XX)
Last Published: Tuesday, May 9, 2023
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>