Q-TRAN QTM-eLED+DALI-DT6-AWN LED Power Supply Installation Guide
- June 12, 2024
- Q-TRAN
Table of Contents
Q-TRAN QTM-eLED+DALI-DT6-AWN LED Power Supply
Must be installed by licensed electrician
WARNING
-
Risk of Fire / Electric Shock
-
Transformer should be installed by a Licensed electrician in accordance with the N.E.C. and all local codes in force.
-
Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
-
This power supply must be installed according to the National Electric
-
Code and local codes and ordinances.
-
This power supply is to be installed and serviced only by an licensed electricians.
-
This power supply is to be installed so that it is not likely to be contacted by people.
-
To avoid a hazard to children, account for all parts and destroy all packaging materials.
-
Do not install in wet locations.
INSTALLATION
Node And Conduit Entry Locations
RECESSED MOUNT
SURFACE MOUNT
Conduit Entry Locations
- Athena nodes must be installed on the secondary side of power supply center and require 1.0” of clearance in order to optimally function. Metal conduit must be 1.0” away from any node. Refer to the diagram above for recommendations for conduit entry into secondary compartment.
Lutron Athena Node
- Mounted in the secondary wiring compartment only.
Mounting Options
NOTE: The bracket can also be mounted (Top & Bottom) for Vertical Mounts.
Connecting and Configuring the DALI-DT6 Decoder
NOTE
2-Wire default is 1 address For customization or pre-programming contact a
local sales rep. DALI commissioning to be performed by a third party at time
of installation.
Primary Wiring
Secondary Wiring
WARNING: Risk of electrical shock. May result in serious injury or death.
Disconnect power before servicing or installing.
CAUTION: The device may only be connected and installed by a qualified
electrician. All applicable regulations, legislation and building codes must
be observed. Incorrect installation of the device can cause irreparable damage
to the device and the connected LEDs.
Manual Configuration
Other Features
DT6 Dimming Feature
NOTE: DT6 color type of the dimmer with Lutron Athena Node can be SW
only.
DALI with Lutron Athena Node
QTM-eLED-200W+DALI-DT6-AWN-2-2-2
for interior
CSA Requirements
- Suitable for indoor use
- This power supply must be installed according to the National Electric Code and local codes and ordinances and in accordance with applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
- This power supply is to be installed in a location where it is not likely to be contacted by non-electricians.
- To avoid a hazard to children, account for all parts and destroy all packaging materials.
© 2023 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com.
References
- Your Name as Your Email | Hover Realnames
- LED Lighting Systems, Linear LED Lights, LED transformers | Q-Tran
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>