PEPE P30011 Toilet Grab Rail User Manual
- June 13, 2024
- Pepe
Table of Contents
PEPE P30011 Toilet Grab Rail
CODE
PEPE – TOILET GRAB RAIL: P30011
INTRODUCTION
The PEPE – TOILET GRAB RAIL with roll holder is perfect for people with difficulty getting up, risk of falling or with reduced mobility, providing help and security. Don´t use this product without reading and understanding the instructions. If necessary, contact a healthcare professional or technical personnel to avoid possible injury.
ASSEMBLY
The box contains screws (6) and wall plugs (6), to be installed on a wall. Examine the bath rail kit. Take everything out of the box and check that the bath rail is in good condition, as well as all the parts. The measurements of the screws are M6x2.3/4” and the wall plugs M8x3.1/8”.
- Set the installation location. In general, the bar has to be at the height of the user’s wrist while standing.
- Mark the installation location on the wall using a pencil in the holes in the base. Use an 17/64” drill bit to drill the holes and insert the plugs where the screws will be inserted, using a hammer if necessary.
- Fix the screws through the holes in the base positioning the bath rail on the wall and tight the 6 screws in the holes. It is recommended to use an electric screwdriver.
- Pull the bar hard to test its supporting.
CARE AND CLEANING
- Cleaning with a microfiber cloth with hot soapy water. Maximum 140ºF.
- For the most stubborn stains you can use a sponge, but it is essential not to use scourers, bleaches or abrasive products.
- We recommend cleaning before the first use, after each use and whenever there is contact with body fluids.
GENERAL WARNINGS
- For a correct use of the device always consult your doctor or therapist.
- Make sure the product is delivered complete and keep it packed away from heat sources. Don´t use the product if it is damaged.
- The bath rail supports 220 lb.
- Don´t install on hollow walls, wooden walls or walls that are less than the length of wall plugs and screws.
- We recommend using only one user at a time.
- Use the screws that come with the bath rail, check it monthly and retighten if necessary.
- Use the device for the purpose for which it was designed. The company is not responsible in any way for any misuse of the toilet grab rail, or for injuries or damage caused as a result of it.
- Any serious incident related to the product must be reported to the manufacturer and the competent authority of the Member State in which the user and patient are established.
TECHNICAL SPECIFICATIONS
| MATERIAL | USER MAX. WEIGHT | WIDTH BAR | COLOR |
|---|---|---|---|
| White lacquered steel | 220 lb | 1.18” | WHITE |
| LENGHT | TOTAL MEASURES | SUPPORT MEASURES | WEIGHT |
| --- | --- | --- | --- |
| 30” | 30” x 7” | 11.8” x 5.1” | 6 lb |
CUSTOMER SUPPORT
IMPROVING MOBILITY DEVELOPMENT S.L.
Avda. Mare Nostrum 1, Bloque 1, Pta 16
46120, Alboraya, Valencia, Spain
admin@kmina.com |
www.kmina.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>