PURe geaR PureBoom Mighty Mini Wireless Speaker User Manual
- June 13, 2024
- PURe geaR
Table of Contents
PureBoom Mighty
Puissant PureBoom
User Manual
PureBoom Mighty Mini Wireless Speaker
Connecting / Bluetooth Pairing
- Make sure the PureBoom Wireless Speaker is within 2-3 feet (0.6-0.9 meters) of the device you will be connecting to.
- Turn on your device’s Bluetooth. Most devices will automatically detect your speaker. Locate and select “PureBoom Rugged Mini Speaker”. It will indicate that your speaker is now connected or paired.
If your device does not automatically detect the speaker, make sure Bluetooth
is turned on. Locate “PureBoom Rugged Mini Speaker” then click connect.
If you’re still having trouble, try turning off the speaker then turn it on
again. Make sure the speaker is in pairing mode indicated by a flashing blue
light.
Operating PureBoom Wireless Speaker
When playing music:
-
To skip to the next song, short press the + button once.
-
To skip to previous song, short press the – button once.
-
To play/pause, press the play button once.
When on a call:
- To answer or hang up a call, press the play/pause button once.
- To reject a call, press and hold the play/pause button.
- To increase volume, long press the + button to your desired volume.
- To decrease volume, long press the – button
Pairing 2 Speakers
-
Make sure both speakers are not connected to your phone/device’s Bluetooth.
-
Speakers will prompt “Power on, Bluetooth mode”.
-
Press and hold the Play/Pause button on one of the speakers until you hear a beep on both speakers.
Note – the beep will go off on the first speaker then followed by the second speaker. -
One speaker’s LED light will flash blue while the second speaker’s blue LED will remain on if the pairing is successful.
-
Follow “Connecting/Bluetooth Pairing Instructions” to connect the speakers to your phone.
Features and Specifications
Frequency Response: 20Hz – 20KHz
Charging input: DC5V, 500mA
Li-ion battery size: 1200mAh
Drivers: Ø57/5W
Impedance: 4 ohm
NOTE: The speaker cannot charge other products, so there is no charging
output.
FCC Statement
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC ID: 2AIIF09969PG
pure-gear.com
© 2022 | F00193PG | 64120PG
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>