HOLLYLAND Solidcom C1 Pro Wired Headset for Hub User Manual
- June 13, 2024
- HOLLYLAND
Table of Contents
HOLLYLAND Solidcom C1 Pro Wired Headset for Hub
Interfaces
Product Installation and Usage
Wired Headset Installation
- Plug the headset into the 0B10 headset interface on the hub and rotate the nut clockwise to secure the headset.
- Move the microphone boom down, and you will hear a “tick” sound. Then, you can start to talk.
Microphone Boom Indicator Description
- Steady green light: ENC OFF
- Steady blue light: ENC ON
- Steady red light: MUTE
Button/Switch Description
- TALK/MUTE Button
- Press the button to switch between the TALK and MUTE modes. The indicator light turns red when the MUTE mode is enabled.
- Press and hold the button to enter the TALK mode (PTT function), and then release the button to switch to the MUTE mode.
- ENC Switch
- When the switch is pushed to the ENC position, yellow is displayed and ENC is enabled.
- When the switch is pushed away from the ENC position, black is displayed and ENC is disabled.
Parameters
Safety Precautions
- Do not place the product near or inside heating devices (including but not limited to microwave ovens, induction cookers, electric ovens, electric heaters, pressure cookers, water heaters, and gas stoves) to prevent the battery from overheating and exploding.
- Do not use non-original charging cases, cables, and batteries with the product.
- The use of non-original accessories may cause electric shock, fire, explosion, or other dangers.
Support
If you encounter any problems in using the product or need any help, please contact Hollyland Support Team via the following ways:
Statement
All copyrights belong to Shenzhen Hollyland Technology Co., Ltd. Without the
written approval of Shenzhen Hollyland Technology Co., Ltd., no organization
or individual may copy or reproduce part or all of any written or illustrative
content and disseminate it in any form.
Trademark Statement
All the trademarks are owned by Shenzhen Hollyland Technology Co., Ltd.
Note: Due to product version upgrades or other reasons, this User Manual
will be updated from time to time. Unless otherwise agreed, this document is
provided as a guide for use only. All representations, information, and
recommendations in this document do not constitute warranties of any kind,
express, or implied.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the device. This
device complies with Part 15 of the FCC Rules.
Operations are subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operations.
FCC Radiation Exposure Statement:
The device has been tested and complies with FCC SAR limits.
Note: This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy,and if it is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the device and the receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>