Pinghu Shuangxi Baby Carrier Manufacture HY2021TX Remote Controller User Manual
- June 4, 2024
- Pinghu Shuangxi Baby Carrier Manufacture
Table of Contents
Shuangxi Baby Carrier Manufacture HY2021TX Remote Controller
User Manual
HY2021TX Remote Controller
- Before first using, please code first, steps are as follows: (1)Press and hold the car select button until the remote indicator light starts to flash. (2)Turn on the power, and the remote indicator light will be off, indicating a successful connection with the car. Release the button, now the remote control can be used. (3)If the remote indicator light is still flashing and turns on, try again and repeat steps 1-2.
- Please select the proper speed during driving. Manual mode or remote mode all can be selected. (1)remote mode: press and hold the speed select button to choose the proper speed. (1 LED: slow speed; 2 LED: middle speed; 3 LED: fast speed.) (2)Manual mode: use gear to select high or low speed.
- The remote control uses slow start technology, it can reduce the impact force of the traditional controller and protect the baby’s spine.
- The “stop” button on the remote control can be used in any situation (after coding successfully), press and hold the “stop” button, and the car will stop immediately and can’t operate whether in manual mode or remote mode. Parents have full control of the remote, which can improve security.
- Push the joystick front, and the car will go forward. Push the joystick back, the car will go backward. No operation, the car will not move.
- Push the joystick left, and the car will go left. Push the joystick right, the car will go to the right.
- Combine the operation of the “left” and “right” buttons, and the more fun the children will get during driving.
FCC Caution
(1)§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
§ 15.21 Changes or modification warning
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. §
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.