SEVIZ AZ-W9 Wood Bluetooth Stereo Speaker User Manual

SEVIZ AZ-W9 Wood Bluetooth Stereo Speaker

Please read this instruction carefully before use

Appearance function description

1. Prev/ volume
2. Play/Pause/FM scanning
3. Next/ volume+
4. Mode button
5. Microphone
6. TF card
7. AUX
8. DC SV charging port
9. ON/OFF

Product feature

1. Bluetooth version 5.0.Receive audio signal within lOM
2. Wooden box,reproduces the better sounds
3. Unique bass boost technique
4. Support TF card playing Mp3
5. Support FM radio
6. Equipped with AUX port
7. Micro USB port for charging
8. Built-in 1500mah lithium battery,which can support 5 hours

Technical index

Output power: 10W*4
Loudspeaker size: 52mm
System frequency: 80Hz-16KHz
Signal-to-noise ratio: ~60dB
Input sensitivity: 600±100mV
Distortion degree: :50.3%(1W lKHz)
Product size: 38″9″8cm
Charging voltage: DCSV l000mA
Play time: 4-5 hours
Full charge time: 3 hours

Basic operntion instructions

1. Power On: move 9 key to ON side, the power is on and automatically search other bluetooth devices

2. Bluetooth:

   Re-link: when power is on, the product will try to re-connect the previous linked device,if can not, then back to auto searching aferabout 10 sec.
   Matching: turn your device on, tap the “matching” when it searched FOUR40W- SEVIZ, in normal condtions, its password free.
   Bluetooth is peer-to-peer connection, so only one device can be connected at the same time. When connected, the match cannot be deleted, please disconnect first.

3. Play music: press 2 key shortly and it will play music in about 2 seconds, press it again to pause.

4. Volume adjust: by long pressing 1 keyor3 key.

5. Next/Prev: by short press 1 key or 3 key.

6. TF card: plug the TF card with MP3 files into the slot in correct direction.the product will automatcally switch into TF card mode,and play music in your TF card, Volume adjust and Next/Prev are the same as nommal mode.

7. FM: short press 4 key to switch it into FM mode,and press the 2 key to auto scaning.press 1 key for last channel,press 3 key for next channel.

8. AUX: Use the attached 3.5 audio line to connect speaker and the other end to connect the external sound source.

9. Recharging:

   When the battery is low, the speaker will remind the user to recharge
   When charging, the red light is on. The rated charging parameter is DC-5V 1000 mAh,please use standard recharger in case to cause the circuit and battery.
   When use the speaker for the frst time, please recharge it after full discharge, the first three charging shall up to 8 hours to extend the work life of the battery.

Notice

1. The product is anti-interference,but very strong high frequence microwave and magnetic field will still interfere the product,please don’t use it in such conditions.
2. Bluetooth is two-way transmission,different user’s terminal have different transmission range,please use standard Bluetooth players.
3. Some phone’s player doesn’t have fade-in and fade-out function,it may cause POP sound when pause.
4. The modes are isolated from each other,it can’t work in two modes at the same time.
5. If the speaker will be placed aside for long time,please recharge it once a month,to maintain the battery capacity.

SEVIZ wireless speaker
model: FOUR40W-SEVIZ

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>