Gude GAB 12V-1A Automatic Battery Charger Instructions

: June 12, 2024
: Gude

Gude GAB 12V-1A Automatic Battery Charger

Gude GAB 12V-1A Automatic Battery Charger

Please read the instructions carefully before starting the machine

DELIVERY RANGE

Charging

GAB 12V-1A 85144

Charging GAB 12V-1A 85144

Charging GAB 12V-1A 85144 Charging current

GAB 12V-4A 85145

Charging GAB 12V-4A 85145

Hold charge

Charging – 6V

GAB 12V-4A 85145

Charging - 6V

Battery Voltage GAB 12V-4A 85145

Error codes and display

| | | |
---|---|---|---|---

The battery is fully charged

| The charge does not begin| The charge does not begin| The charge does not begin|

The charge voltage is too low

After the battery is fully charged, the maintenance cycle begins. The battery charger automatically monitors the charge maintenance

| The battery clamps are connected with reverse polarity.| The battery voltage is not matched with the selected mode.| The battery is defective.|

The battery is deep discharged or defective.

Look every 8 hours

| Disconnect & reconnect correctly| Confirm that battery voltage is matched with the mode.| Replace the battery.| First charge for over 12 hours on „RECOND“, when the battery has a normal voltage again, it is regenerated.

Technical Data

BATTERY CHARGER

| GAB 12V-1A| GAB 12V-4A
---|---|---
Art. No| 85144|

85145

Mains voltage / Mains frequency

| 220-240 V /~ 50 Hz| 20-240 V /~ 50 Hz
Output voltage| 6 V / 12 V|

6 V / 12 V

Weight

| 0,33 kg| 0,5 kg
Safety class| II|

II

Rated capacity

| 4-30 Ah| 4-120 Ah
Charging rms current| 1 A|

1 A

Read and understand the operating instructions before using the appliance. Familiarise with the control elements and how to use the appliance properly. Abide by all the safety measures stated in the service manual. Act responsibly toward third parties.
The operator is responsible for accidents or risks to third parties.
In case of any doubts about connection and operation refer please to our customer center.

Safety Instructions

WARNING

Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.

The product is designed for use by persons aged 16 or older.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision. To avoid danger, a damaged mains supply pipe must be replaced by the manufacturer.

WARNING! Electric shock! There is a risk of an injury caused by electric shock!
Never operate the apparatus if a cable, the mains cord or plug are damaged. Damaged mains cords pose a hazard of electrocution.

Risk of fire! Risk of explosion!
A highly-explosive oxyhydrogen mixture occurs when batteries are charged.

Fire, sparks, naked flames and smoking are forbidden.
Provide adequate ventilation.
Do not use the device in rooms in which easily flammable material or gases may be present.

Never use the charger in moist or wet conditions.
Make sure the cooling function is not limited by covering the cooling slots. Do not operate the appliance near heat sources or on a flammable surface.
Only connect or disconnect the battery connection cable if the charger is not connected to the mains.
Also pay attention to the instructions and information provided by the battery and vehicle manufacturer.
Ensure that the vehicle is switched off if the battery is mounted fixed in the vehicle! Switch off the ignition. Park the vehicle and secure it0.

Plug the charger into a mains socket.
Select the mode you need.
Connect the red battery clamp to the positive terminal of the battery first.
connect the black battery clamp to the negative terminal of the battery (when installed, to the body, away from the battery and fuel line).
after charging: Unplug the charger from the socket.
first remove the black clamp from the body and then the red clamp from the battery.

Translated with www.DeepL.com/Translator (free version).

This sequence must be followed!
Danger of short circuit! Make sure that the two clips of the pole connecting cables do not touch or are connected by a conductive object, such as a tool.
Handle the terminal connecting cable (“–” and “+”) only by the insulated sections!
Never hold both clips at the same time when the device is running.

Specified Conditions Of Use

The battery charger is only to be used for charging of vehicles taking all technical data into consideration.
Types of batteries:

Lead acid batteries (liquid electrolyte) (PB)
Gel battery (GEL)
Absorbent glass mat battery (AGM))
Wet-cell batteries (WET)
Maintenance-free lead acid batteries (MF)
LiFePO4 batteries (85145 – GAB 12V-4A)

WARNING
It is not suitable for charging NiCad or NiMH batteries and other non- rechargeable batteries, for example.

Please note that our equipment has not been designed for commercial, craft or industrial use. If the equipment is used in commercial, craft or industrial operation or for similar activities, we cannot assume any liability.

Do not use this product in any other way as stated for normal use. Not observing general regulations in force and instructions from this manual does not make the manufacturer liable for damages.

Residual risks

Even when the device is used properly and all safety regulations are complied with, there still may be some residual risks.

WARNING!
Wear eye protective goggles ! Wear gloves! Keep children away from acids and filled batteries.

Corrosion Hazard!
Battery acid is highly caustic.

First Aid
Rinse out any acid splashed into the eyes immediately using clear water for several minutes. Consult a doctor immediately.
Neutralise acid splashes on skin or clothes immediately using acid neutraliser or soap suds and rinse with plenty of water.
If acid is consumed, consult a doctor immediately.

Emergency procedure

Conduct a first-aid procedure adequate to the injury and summon qualified medical attendance as quickly as possible. Protect the injured person from further harm and calm them down. If you seek help, state the following pieces of information: 1. Accident site, 2. Accident type, 3. Number of injured persons, 4. Injury type(s

Mains Connection

Operation is only allowed with a safety switch against stray current (RCD max. stray current of 30mA).

Before putting into operation, a qualified electrician must check whether electric safety measures required are in place. Any national regulations in this regard must be complied with.
Electric connection to a socket.
It is necessary to make sure the connecting socket was not near water and humidity and the plug was protected against humidity.
Check the voltage. Technical data given on the type label must correspond with electric network voltage.
Only use splash proof extension cables approved for outdoor purposes.
Check the cable and/or socket for damages before the appliance putting into operation.
Never use the charger when the cable, plug or the machine is damaged by external influences. In case damage let repaired in authorized workshop.
To avoid danger, a damaged mains supply pipe must be replaced by the manufacturer. Do not under any\ circumstances attempt any repair yourself.
Cable connections to be separated by pulling the plug only. Pulling the cable could damage both the cable and plug. As a result, electric safety would no longer be guaranteed.

Over-temperature protection
The power will automatically be reduced should the apparatus heat up too much during charging. This will protect the apparatus.

Symbols

|

WARNING/Caution!

---|---
|

Warning against dangerous electric voltage

|

Read the operating instructions to reduce the risk of injury

|

Wear eye protective goggles !

|

Wear gloves!

|

Unplug the machine before any work on it.

|

Keep dry at all times. Never expose tool to rain.

|

Charger to be used in closed spaces only

|

AC Current

|

Plus – positive terminal

|

Minus – negative terminal

|

This equipment is in safety class II

|

Direct Current

|

CE marking

Any damaged or disposed electric or electronic devices must be delivered to appropriate collection centres.

Maintenance

Unplug the machine before any work on it.

The connection clamps, clips and the upper surface of the battery must be kept clean; if necessary clean the battery clips with a wire brush.
Repairs and works specified in these Instructions may only be performed by qualified authorised staff.
Use only original accessories and original spare parts.
Before using the appliance, perform a visual inspection at all times to make sure the power cord and the plug, in particular, are not damaged on the charger.
Clean only with dry cloth. Certain cleaning agents and solvents are harmful to plastics and other insulated parts. Keep the apparatus handle clean, dry and free of oil or grease.
Only a regularly maintained and treated appliance can serve as a satisfactory aid. Insufficient maintenance and care can lead to unforeseen accidents and\ injuries.
If necessary, a list of spare parts can be found at www.guede.com.

Disposal

Do not dispose of electric tools together with household waste material.

Pursuant to European Directive 2002 / 96 / EC on Electrical and Electronic waste and to national legislation, electrical and electronic waste must be collected separately and delivered to a recycling facility for environmentally responsible disposal.

Check with your local authority or retailer for recycling advice and collection point.

Battery disposal

Pursuant to the Battery Ordinance you, as the end user, will be obligated to return all used batteries/ rechargeable batteries.
Flat batteries must not be disposed of with household waste. Care for the environment and take them to the collection points provided in accordance with national or local regulations. Please contact your local authority or your dealer for how to dispose of batteries properly.

Guarantee

Warranty period of 12 months applies to commercial use and 24 months applies to private use and commences on the day of purchase of the device.

The guarantee solely covers inadequacies caused by material defect or manufacturing defect. Original payment voucher with the sales date needs to be submitted for any claim in the guarantee period.

The guarantee does not cover any unauthorised use such as appliance overloading, use of violence, damage as a result of any unauthorised interference or caused by foreign items. Failing to follow the operating and assembly instructions and common wear are also not included in the guarantee.

Important information for the customer
Please be sure to know that returning the product in or after the warranty period must be made in the original packaging.

Service

Do you have any technical questions? Any claim? Do you need any spare parts or operating instructions? We will quickly help you and without needles bureaucracy at our web pages at www.guede.com in the Servicing part. Please help us be able to help you. In order to identify your device in case of claim we need the serial No., product No. and year of production. All this data can be found on the type label.

Translation of the EC-Declaration of Conformity

We, hereby declare the conception and construction of the below mentioned appliances correspond – at the type of construction being launched – to appropriate basic safety and hygienic requirements of EC Directives.
In case of any change to the appliance not discussed with us the Declaration expires.

Battery charger 85144 GAB 12V-1A

Directives CE applicable

2014/35/EU
2014/30/EU
1935/2004/EC
1907/2006/EC
2011/65/EU&2015/863EU
2016/426/EU
2016/425/EU (PPE)
2019/1784/EU
2015/1188/EU
2014/29/EU
2006/42/EC

Type Ex. Cert.-No.:
97/68/EC_&2016/1628/EU
Emission No
2000/14/EC_2005/88/EC

Harmonised standards used

EN 60335-1:2012+A11:2014+A13:2017+A1:2019+A14:2019+A2:2019+A15:2021
EN 60335-2-29:2004+A2:2010+A11:2018
EN 62233:2008
AfPS GS 2019:01 PAK
EN IEC 55014-1:2021
EN IEC 55014-2:2021
EN IEC 61000-3-2:2019+A1:2021
EN 61000-3-3:2013+A1:2019

Guaranteed sound power level

LWA dB (A)

Measured sound power level

**LWA dB (A)

**

12/10/2022

Managing Director

Güde GmbH & Co. KG, Birkichstraße 6, 74549 Wolpertshausen, Germany

Authorized to compile the technical file

Customer Support

Tel.: +49 (0) 79 04 / 700-360
Fax.: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com
Birkichstrasse 6
74549 Wolpertshausen
Deutschland
Tel.: +49-(0)7904/700-0
Fax.: +49-(0)7904/700-250
E-Mail: info@guede.com
www.guede.com