JIMMY WB73 Anti Mite Vacuum Cleaner User Guide
- June 12, 2024
- JIMMY
Table of Contents
WB73
Anti-mite Vacuum Cleaner
User Guide
Product Installation
Parts Name
Packing List
| Name | Vacuum Cleaner | MIF Filte | Mini brush | User Guide |
|---|---|---|---|---|
| Quantity | 1 | 1 | 1 | 1 |
Use of the Product
Insert the plug into the socket,when turn on machine, the machine is in UV
light+tap vacuum mode, all indicators light up.Press mode button once, the
machine changes to tap vacuum mode and relevant indicators light up.Press mode
button again,the machine changes to UV light mode .Press mode button once
again, the machine changes back to UV light+tap vacuum mode. Press on/off
button again, the machine stop working.
Dust Sensor Indicator
- When turn on machine,the dust sensor indicator light stays green.
- When the machine vacuums a lot of dust and the indicator light turns red,indicating that the user needs to focus on cleaning this area.
- When the machine vacuums moderate concentration dust and the indicator light turns orange,indicating that the user needs to keep cleaning this area.
- When the machine vacuums little or no dust and the indicator light turns green,indicating that this area does not need to be cleaned.
Note:For safety reasons, the UV light only works within 3cm above object as well as less than 30 inclination degrees. Otherwise, the UV light will automatically turn off.
Cleaning and Maintenance
Note:
- MIF Filters are available at dealers.
- It is recommended to clean the dust cup after each use. when the filter is blocked due to excessive dust accumulation, it needs to be cleaned and replaced if necessary.
Dust Cup Cleaning
- Turn off the machine and unplug the power cord. Then press the release button and lift upward.(Figure 1)
- Hold the dust cup and dust cup lid separately, twist dust cup clockwise (Figure 2), remove it from dust cup to clean.(Figure 3)
Filter and Cyclone Cleaning
Hold the cyclone in one hand, pinch the “UP” logo with the other hand, and
take out filter (Figure 4). Do Not tap the filter in reverse side in case of
filter clog (Figure 5). Clean the cyclone metal filter with the attached mini
brush.(Figure 6)
After cleaning dust cup ,filter and cyclone, put cyclone into the dust cup and
rotate the dust cup lid into the dust cup until until a “click” sound is
heard.(Figure 7)
Note:
- Do Not miss the filter!
- Use water or neutral reagents to clean dust cup and wipe with dry cloths. Do not wash the filter until it is necessary. Make sure the filter and dust cup are completely dry before another use.
Brushroll CleaningBrushroll Cleaning and installation
Turn off the machine and unplug the power cord, rotate the right lock knob
anticlockwise with hand from locked position to unlock position (Figure 8) to
remove the brushroll to clean up.(Figure 9)
After brushroll cleaning,install the brushroll and the brushroll cover into
the machine in turn and lock the latch of the brushroll.
Note: For safety reasons, please turn off the machine and unplug power
cord before cleaning brushroll.
Maintenance and Storage
Please clean dust cup and filter after each use for further use. It is
recommended to replace a filter after 30-50 hours of working time(depending on
specific situation) for better use.
Any paper, lead glass, plastic will greatly affect the effect of UV light.
Please wipe and clean the UV tube regularly for better use.
Do Not touch the UV tube as dirt will affect UV light effect.
Put the machine in cool and dry place if the machine is to be idled. Do Not
leave it in direct sunlight or humid environment.
Cautions
- Please read this instruction manual carefully before use and keep it properly for future use.
- Never leave the machine working without supervision.
- eep this product beyond the reach of special individual such as children without adult supervision.
- Keep the power cord away from sharp objects and do not drag the cord to move the machine in case of cord damage.
- Do not use this product to clean water or wet dust. Do Not operate it in humid places (such as bathroom, toilet, laundry room, etc.)to avoid malfunction.
- This product can ONLY use for cleaning of textiles such as mattresses, blankets, pillows, sofas, etc.
- Do Not place the machine near heating appliances or expose it to direct sunlight in case of fire hazard.
- For safety reasons, please do not use the product to clean hot objects such as carbon, cigarette butts, sharp objects such as broken glass, corrosive liquids, flammable and explosive materials such as gasoline and alcohol. Otherwise it may cause product damage or fire.
- Do Not operate this machine with suction port blocked in case of product damage.
- Do Not remove the brushroll cover or force the cover outward when the machine is powered on for safety reasons.
- The product has UV light, for safety reasons, Do Not look at the bottom of the machine when the power is on in case of ultraviolet rays harming.
- Do Not apply this product to plants. Excessive use of UV may cause object damage.
- Do NOT sit on this product in case of personal injury and product damage.
- Cut the power source in maintenance or off-service.
- If the power cord is damaged, please ask for professional help of the manufacturer and other professionals for safety reasons.
- Please turn off the power switch and unplug the power cord if the machine is to be idled. Do Not unplug the power cord with humid hand in case of electric shock.
Trouble shooting
Please check the following trouble points before go to the maintenance department.
| Problems | Possible Reasons | Solution |
|---|---|---|
| Power failure | Power cord is not firmly inserted | Insert the power cord firmly |
| No power on socket | Check the socket | |
| On/Off button not pressed | Press the On/Off button | |
| Low suction power | Suction port clogged | Clean up suction port |
| Dust accumulation on filter | Clean up the dust cup and filter | |
| Dust accumulation on cyclone | Clean up cyclone | |
| UV light tube failure | The UV function is automatically off for safety reasons | |
| or weak reflection of object | The UV function operates on the condition of |
less than 3 cm height from the object
The machine operates on the same position for a long time| Move the machine
forward and backward
The machine is placed upright| Machine tilted no more than 30 degrees
Sensor window is contaminate| Clean the sensor window with a half-dry cloth
UV light damage| Contact after-sale service
Automatically turned off| Dust cup full| The machine will automatically turn
off to prevent the motor under long operation. If the machine automatically
turned off, please clean up the dust cup and filter, unplug power cord and
reuse if after 2 hours
Suction port clogged
Filter blocked
Brushroll failure| Brushroll tangled with foreign matter| Remove the cover and
clean up brushroll according to user guide
Belt broken| Remove the cover according to user guide and check the belt. If
broken, contact after-sale to repair
Note:If fault remains after adopting the following solutions, contact after sale service or local distributor immediately.
Product Specifications
Technical Parameter
| Model | WB73 |
|---|---|
| Rated voltage | 220V-240V ~ |
| Rated frequency | 50Hz |
| Rated power | 600W |
Circuit diagram
Manufacturer Information
| Manufacturer | Kingclean Electric Co., Ltd |
|---|---|
| Address | No.1 Xiangyang Road, Suzhou New District, Jiangsu Province |
215009, China
Disposal
The machine, accessories and packaging should be sorted for environmental-
friendly recycling.
Do not dispose of the machine into household waste!
Only for EC countries: According to the European Guideline 2012/19/EU, machine
that are no longer usable, and according to the European Guideline 2006/66/EC,
defective or used battery packs/batteries, must be collected separately and
disposed of in an environmentally correct manner.
Subject to change without notice.
Warranty Information
**** This product enjoys one year warranty for the machine，service starting
from the date of purchase.
Excluded from the guarantee is normal wear, commercial use, alterations to the
appliance as purchased, cleaning activities, consequences of improper use or
damage by the purchaser or a third person, damage, that can be attributed to
external circumstances.
Contact us -we’ll get back within 1 business day.
https://www.jimmyglobal.com
Web:www.jimmyglobal.com
Email:support@jimmyglobal.com