deli 3870 Rubber Ring Binding Machine User Manual
- June 12, 2024
- DELI
Table of Contents
User Manual
COMB BIND No.3870 
3870 Rubber Ring Binding Machine
No.3870
Deli Group reserves the right to change product designs and specifications,
without prior notice.
Thank you for purchasing No.3870 rubber ring binding machine of Deli Company.
The multiple functions and elegant design make the product applicable to
individual use and department use. We believe that the rubber ring binding
machine with complete functions will make your document binding have higher
efficiency.
To make you correctly use the product and prevent the inconvenience caused to
you and other people, please carefully read this manual.
Product apparent structure and the names
Direction for use
-
The machine is used for punching of paper and plastic cover, and plastic clip is used for loose-leaf binding.
The machine only can be used for this purpose, and please use it according to the operation instruction. -
Before punching of the original materials, do remember to use waste paper to test whether the machine works normally.
-
Empty the waste paper container periodically.
-
The upper limit number for punching is 12, and this number shall not be exceeded.
Attention
Put the machine on the stable and safety table before use.
- Insert paper and adjust “Locating block” to centre the paper. Select adjustable cutters to set hole punching.
- Pull down the handle to punch holes, then lift back to the original place.
- Place the piastic rings to the back of comb opening upward.
- Push the handle backward and let the hooks engage the rings to open the plastic rings.
- Insert the binded paper into the plastic rings.
- Push the handle backward and fininshed of the file.
Common fault analysis and troubleshooting
| Fault phenomenon | Fault cause analysis | Troubleshooting method |
|---|---|---|
| It is hard to press the handle when paper punching | There is paper scrap or | |
| other hard object in the paper cutting port | Take out the sundries with |
chipboard.
The operation is beyond the punching capacity described in the instruction.|
Operate according to the requirements of the instruction.
The punching edge distancehas inclination phenomenon.| The two sides of the
incoming paper are unbalanced.| Take out the paper and then re-operate
There is paper scrap or other hard object in the paper cutting port.| Take out
the sundries with chipboard.
The open rubber ring has inclination phenomenon.| The comb plate has
deformation caused by collision.| Straighten the comb plate with a ruler.
The draw hook of pull ring has deformation.| Pull the pullrig tp calibra teth
e claw hook with hands.
Incomplete paper punching or the paper is hard to draw out.| The number of
pieces of paper for punching at a time is too large.| Reduce the punching
thickness of each time (based on the requirements of the instruction)
The paper cannot reach the bottom.| The paper is unserviceable and the paper
edge coils.| Smoothen the paper and then re-operate.
Productc parameters
| Binding specification | A4 paper or below | Maximum punching number | 21 holes |
|---|
Hole dimension
Distance between holes| 3mmxii-nm /14.3mm| Margin Adjustable| 3mm/4mm/5mm
Maximum binding thickness| 350 pieces (70g/m² paper)| Maximum punching
thickness| 12pieces(70g/m² paper)
Net weight| 3.46kg| Overall dimension| 385x275x360mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>