deli 4078 Electronic Password Safe Household Small Safe Office Box Instruction Manual

: June 4, 2024
: DELI

deli 4078 Electronic Password Safe Household Small Safe Office Box

deli
4078 Electronic Password Safe Household Small Safe Office Box
PRODUCT

Welcome to use our series products of safes (cabinets) and safe deposit boxes. Please read the instruction manual carefully before use, and operate correctly according to the instructions.

Product Unpacking

Check that product appearance is intact after unpacking the box and checking all accessories. Please contact the dealer if anything is broken. deli 4078
Electronic Password Safe Household Small Safe Office Box FIG
1

Product Schematic

deli 4078 Electronic Password Safe Household Small
Safe Office Box FIG 2

Box
Panel
Handle
Reset key
LED lamp
Backside cover
Internal battery compartment
Slide cover
Main lock key hole
Display screen
Keys
Emergency key hole
External power supply socket

First Use

Push the slide cover to the left to the limited position;
Insert one of the main lock keys and one of the emergency keys into the corresponding key holes on the panel, respectively, first turn the emergency key clockwise, then turn the main lock key and handle clockwise to open the door.
(Turn the main lock key clockwise to open the door for the products without a handle)

Battery Installation

(alkaline battery is required)

Put the four 5# batteries into the internal battery compartment located on the backside of the door according to the correct polarity. A “beep” will sound after the power is supplied;
Enter the factory password “12345678”;
Press the key “#” to confirm, and the display shows “OPEN”. Please turn the main lock key and handle clockwise within 6 seconds to open the door.

Password Setting

The factory password of this product is “12345678”.Please reset your personal password before use to ensure safety.

Enter the factory password “12345678”and confirm it by pressing the key “#”, and the display shows “OPEN” ;
After “OPEN” goes out on the display (please set a new password within 25 seconds), press the Reset key on the backside cover of the door and the display shows “set” ;
Enter a 1-8 digit password;
Press the key “#” to confirm. The display shows “into 1”, and the new password is set.
Tip: Verify the new password after the password is set, and then lock the door after confirmation.

Door Closing Operation

Closing the door;
(a) For the products with a handle: turn the handle counterclockwise, then turn the main lock key counterclockwise and pull it out.
(b) For the products without a handle: turn the main lock key counterclockwise and pull it out.

Keyless Opening

Push the slide cover to the left to the limited position, and insert one of the main lock keys into the main lock key hole;
Turn the main lock key 90° clockwise and pull it out to turn on the keyless door opening mode;
After this mode is turned on, only enter the correct password to pass the verification or use the emergency key, and turn the handle to open the door;
Remark: In order to turn off this mode, only when the door is open, insert the main lock key into the main lock hole, turn it 90° counterclockwise and pull it out.

Hidden Code Function

In the standby state, the display only shows “–” instead of digits when pressing the key “#” and entering the password.
The digit display is automatically restored after the door is opened.

Deleting Incorrect Password

If an incorrect password is entered during the operation, it can be deleted by using the key “” before pressing the key “#” to confirm. The password of entire line will be deleted by pressing the key “” once. Please enter the correct password again at this time to open the door.

Alarm Function

Wrong password alarm

1. The display shows **“Error”** each time an incorrect password is entered;
2. It will alarm for 50 seconds if the wrong password is entered consecutively for three times;
3. Entering the correct password during the alarm can stop the alarm.

Vibration alarm

1. Press the key “*” in the standby state, the display shows “ALERT ON”, and the vibration alarm mode is turned on at this time. The vibration alarm is automatically turned off after the door is opened normally;
2. Entering the correct password during the alarm can stop the alarm, and automatically turn off the vibration alarm function at the same time.

Battery Replacement

When the voltage of the batteries drops to a certain level, the display will show “Lo bat” after the password is entered each time, indicating that the battery voltage is insufficient, please replace with new batteries as soon as possible. (It is recommended that you use 5# alkaline batteries).

Emergency Opening

Please provide power by using the external battery compartment when the batteries are depleted and the operation cannot be made. Insert the plug of the external battery compartment into the external power supply socket located on the side of the panel, and enter the correct password to open the door.
Please use the emergency key to open the door when the electronic system fails or the password is forgotten. The way to open the door is the same as the first use.

Precautions for Use

Do not put the user’s manual, main lock keys, emergency keys and external battery compartment in the box, they should be stored in other safe place;
The batteries should be taken out to prevent the leakage of liquid from damaging the electronic system if the product is left unused for a long time；
Always fix the cabinet to a solid concrete wall for safety；
Do not store too much cash and valuables when unattended or without a remote alarm device.

Common Faults and Troubleshooting

Symptoms	Causes	Troubleshooting

No any response when pressing the digit keys to enter the password

|

The batteries are depleted

| Use the external battery compartment or the emergency key to open the electronic code lock

and replace the batteries

Battery polarity reversed| Insert the batteries properly
Circuit board failure| Please contact the maintenance department

The main lock key cannot be inserted in or removed

| There are foreign objects in the key hole| Remove foreign objects in the key hole
The key is not turned to the limit| Please reinsert in the correct way

The door cannot be opened when the electronic code lock has been opened

| The handle is not turned to the limit| Please turn the handle to the limit
Turn the handle for more than 7 seconds, the electronic lock has been

reset

| Enter the password again and turn the handle to the limit within 6 seconds
The alarm does not sound| The batteries are depleted| Please replace the batteries
Battery polarity reversed| Insert the batteries in the correct way

After-sales Service

Dear users:
Thank you for purchasing our products. In order to ensure the interests of users, all users who purchase our products can contact the local dealer or special maintenance station by the proof of warranty card if the product fails due to quality problems.

Warranty notice:

If the product fails under normal use within one year from the date of purchase by the user, our company will provide free repair, parts replacement and other services according to the failure situation;
This warranty card and purchase invoice are the proofs that our company provides after-sales service to customers. Please fill in the following form on this card, and it will be valid only after the dealer affixes the official seal;
In one of the following cases, free repair service is not provided, and user will be charged for maintenance:
The validity period of the warranty has expired;
Damage caused by improper use, maintenance or storage not in accordance with the requirements of the product instruction manual;
Product failure or damage caused by force majeure;
Wear parts or accessories.
Damage caused by excessive screwing of the product during use.
This card comes together with the product, and one card for one machine. In order to ensure that you have full right to the free repair service provided by our company, please keep this card properly, and you can not get another copy if you lose it.