deli 50454 Electric Motorized Projection Screen User Manual

deli 50454 Electric Motorized Projection Screen

Care and maintenance

1. Keep the screen away from doors, windows, and fans to avoid damage caused by blowing air.
2. Keep the screen away from direct sunlight or rain to slow aging.
3. While expanding the screen, do not pull forcefully, try to exert even force, retract the screen in a vertical position.
4. Do not touch the surface of the screen with sharp objects to avoid damage to the screen.
5. When not in use, retract the screen into its shell to avoid dust accumulation.
6. Stains on the surface of the screen should be wiped clean gently with a cotton cloth dipped in neutral detergent or water. Only use or retract the screen after drying.

Note: If the batter1,1 level is low, please replace the batteries. We recommend that 1,1ou use a point1,1 tool (such as a small, slotted screwdriver) to pr1,1 open rear cover of the remote control. then remove the cell batteries from the white holder at the bottom and replace them with new ones. (As shown on the left)

Packing list

Please check if the product is intact after unpacking and verify that all the accessories have been received. If any items are missing, please contact your dealer.

Note: This diagram is for reference only, please take the actual product as standard.

Instructions for Use

Connect the 220V AC power supply
Lower the screen: Press the “V” button on the switch
Retract the screen: Press the “/\” button on the switch
Stop retracting/lowering: Press the ” -” button on the switch When fully lowered or retracted, the screen will automatically stop.

Reminder:
The motorized screen should not be operated continuously for more than 5 minutes at a time, or the motor will overheat and possibly suffer damage. If operated continuously for more than 5 minutes, allow 5 minutes of rest before using the screen again.
The projected image may suffer from distortion when using a short-focus or ultra-short­ focus projection equipment.

Installation method

1. Wall installation
   Measure the distance between the mounting holes. You may find two keyhole- shaped hanging rings at both ends of the casing. To hang the projection screen on a wall. drill holes with an electric drill (<D Bmm drill bit) at the appropriate positions on the wall. install the expansion anchors and screw in the self-tapping screws (leave a space of 5mm between the screw and the anchor). and then hang the screen.

2. Ceiling installation
   When ceiling installation is required, measure the distance between the hanging rings, drill holes in the appropriate positions on the ceiling with an electric drill (<DBmm drill bit), install the expansion anchors and screw in the expansion hook screws and tighten the nuts, and then hang the screen by attaching the rings at both ends of the casing.

Note: The distance between drilled holes required to install the electric motorized projection screen should be determined by the actual measurement value. Please use metal expansion hook screws (<D 8mm drill bit) to mount on hard brick or concrete walls. To mount your screen on ceiling, please hire a professional installation team.

Warranty Card

Dear customers:
Thank you for your purchase of our products. The interests of customers who purchase our products will be protected. For any malfunction due to product quality problems. please contact authorized local dealers or service centers with this receipt and the warranty card.

Warranty terms:

1. For product failures occur under normal operating circumstances, free of charge repair service shall be provided by our company within one year commencing from date of purchase. (If factory repair service is needed, customer shall bear the freight for delivery of the returned product.)
2. Customers are required to present this warranty card and the original purchase invoice to our company upon request for warranty service. This warranty card shall be valid only after the following form is filled out in details and affixed with official seal of the dealer.
3. No free of charge repair service shall be provided in the event of any of the following circumstances:
4. Expiration of the warranty period;
5. Damages caused by improper use, maintenance or storage not in accordance with the requirements of the user manual;
6. Failure or damage resulting from unauthorized disassembly, repair or modification;
7. Failure or damage caused by force majeure.

This warranty card is being delivered with the product. one card for one product. Please keep this warranty card in proper condition for free warranty service. There is no replacement if lost.

[ Date of Purchase: MM/DD/YVYY ]

Documents / Resources

| deli 50454 Electric Motorized Projection Screen [pdf] User Manual
50454, 50455, 50456, 50455S, 50456S, 50454 Electric Motorized Projection Screen, 50454, Electric Motorized Projection Screen, Motorized Projection Screen, Projection Screen, Screen
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>