WAMPLER WMP-PHD-PED Phenom Distortion Pedal User Guide

: June 12, 2024
: WAMPLER

Table of Contents

WAMPLER WMP-PHD-PED Phenom Distortion Pedal
WAMPLER Pedals Limited Warranty
RETURN PROCEDURES
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WAMPLER WMP-PHD-PED Phenom Distortion Pedal

The COLLECTIVE from Wampler Pedals is an exciting series of versatile pedals with unique, huge tones, and a minimalist interface for ease of use.
The Phenom Distortion is a medium to high gain distortion pedal that offers a range of tones from a deep punchy rhythm sound to an ultra-responsive dynamic lead tone that is perfect for soaring solos and crisp harmonics.

WELCOME TO THE COLLECTIVE.

Volume: Controls the total output volume.
Gain: Adjusts the total amount of gain that is applied, turning this control clockwise will increase the amount.
Bass / Mids / Treble: Adjust the amount of low-end / high-end frequencies, turning clockwise will increase the levels, counter clockwise to decrease.
Mode Switch: Select between two distinct voicings – Bright and Classic.
Power: This pedal was designed around the usage of a 9-18V DC power source only. To avoid damage to the pedal, do not exceed 18V DC, do not use center pin positive adapters, and do not use AC power. Use only a 9V DC power source that is intended for guitar pedals. This pedal draws approximately 5mA at 9-18V.
Note: The pedal has 5 internal trimpots, carefully configured to tune the distortion performance. These should not be adjusted under any circumstance.

WAMPLER Pedals Limited Warranty

WAMPLER offers a 5 year warranty to the original purchaser that this WAMPLER product will be free from defects in material and workmanship. A dated sales receipt will establish coverage under this warranty. This warranty does not cover service or parts to repair damage caused by accident, ne-glect,normal cosmetic wear, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures and service, repair or modifications to the product, which have not been authorized by WAMPLER. If this product is defective in materials or workmanship as warranted above, your sole remedy shall be repair replacement as provided below.

RETURN PROCEDURES

In the unlikely event that a defect should occur, follow the pro-cedure outlined below. Defective products must be shipped, together with a dated sales receipt, freight pre-paid and insured directly to WAMPLER SERVICE DEPT – 5300 Harbor Street, Commerce, CA 90040, USA. A Return Authorization Number must be obtained from our Customer Service Department prior to shipping the product. Products must be shipped in their original packaging or its equivalent; in any case, the risk of loss or damage in transit is to be borne by the purchaser. The Returns Authorization Number must appear in large print directly below the shipping address. Always include a brief description of the defect, along with your correct return address and telephone number. When emailing to enquire about a returned product, always refer to the Return Authorization Number. If WAMPLER determines that the unit was defective in materials or workmanship at any time during the warranty period, WAMPLER has the option or repairing or replacing the product at no additional charge, except as set forth below. All replaced parts become a property of WAMPLER. Products replaced or repaired under this warranty will be returned via ground shipping within the United States freight prepaid. WAMPLER is not responsible for costs associated with expedited shipping, either to WAMPLER or the return of the product to the customer.

INCIDENTAL OR CONSEQUENTIAL DAMAGE

In no event is WAMPLER liable for any incident or consequential damages arising out of the use or inability of the possibility of such damages, or any other claim by any other party. Some states do not allow the seclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you.

This warranty gives you specific legal rights and you may also have other rights which may vary from state to state.

FOR YOUR PROTECTION
Please complete the online warranty registration within (10) ten days of the date of purchase so that we may contact you directly in the event of a safety notification issued in accordance with the 1972 Consumer Product Safety Act.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantees that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experience radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s warranty to operate the equipment.

CUSTOMER SUPPORT

Our dedicated staff are ready to help you with any warranty or product questions – please email us at help@wamplerpedals.com or call us on 765-352-8626 Please remember to register your pedal as soon as possible after purchase at the following web page to ensure quicker service if you should ever need to make a warranty claim: wamplerpedals.com/warranty-registration

visit wamplerpedals.com for full manual and product videos