ZOSI C306 Pro Smart Battery IP Camera User Guide
- June 12, 2024
- ZOSI
Table of Contents
ZOSI C306 Pro Smart Battery IP Camera
Product Information: Smart Battery IP Camera
The Smart Battery IP Camera is a wireless camera that is designed for easy installation and usage. It comes with various features such as an HD lens, infrared LEDs, microphone, PIR sensor, white LED spotlight, and network indicators. The camera also has a built-in loudspeaker, power switch, micro SD card slot, reset button, and a micro USB port for charging.
The camera is equipped with network indicators that provide status information. A blue light indicates that the camera is paired or awake, a slowly flashing red light indicates that it is waiting for pairing with an NVR (Network Video Recorder), a solid red light indicates low battery, and both red and blue lights off indicate standby mode.
The camera has buttons for power and reset functions. Long-pressing the power button for 1 second powers on/off the camera, while long-pressing the reset button for 3 seconds resets the camera to enter pairing mode.
What’s in the Box
Camera
- Antenna
- HD Lens
- Infrared LEDs
- Microphone
- Network Indicator
- PIR Sensor
- White LED Spotlight
- Adjusting Screw
- Release Button
- Power Switch
- Loudspeaker
- Charge Indicator
- Micro SD Card Slot
- Retaining Screw
- Reset Button
- Micro USB Port
Description of the Camera Network indicators:
- Blue light on: The camera is paired or woken up
- Red light fleshes slowly: Waiting for pairing with NVR
- Red light on: Low Battery
- Red and blue lights off: In Standby
Description of the Camera Buttons
- Long press power button for 1 second: Power-on/Power-off
- Long press reset button for 3 seconds: Reset to enter pairing state
(The red light flashes slowly after the voice prompt)
Product Usage Instructions
Camera Installation
Option 1: Placing the Camera on a Flat Surface
- You can place the camera on any flat surface like a table, chair, or floor.
Option 2: Installing with Wall Mount
- Drill 5 holes according to the position of the mounting base. and Mount the base on the wall using the included pack of screws.
- Lock the two slots on the camera base to the hook on the mounting base.
- Install and tighten the safety set screw.
- Insert and tighten the screw on the bottom of the camera battery pack.
- Use the included screwdriver to adjust the camera to a proper angle and tighten the adjustment screw.
Pairing the Cameras with the NVR
- Place the camera near the NVR at a distance of 30~100cm.
- In the power-on state, press and hold the reset button of the camera for 3-5 seconds.
- After hearing a voice prompt from the camera, open the NVR system interface.
- Use the camera to scan the QR code (Phone port number) on the NVR for pairing.
- The camera will give out a voice prompt to indicate successful pairing.
For more information, please refer to the www.zositech.com website or contact support at support@zositech.com.
All rights reserved. No part of this publication may be reproduced by any means without written permission from ZOSI. The information in this publication is believed to be accurate in all respects. ZOSI cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
For more information of this camera please refer to www.zositech.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>