VISUAL COMFORT KW 2702 Avant Medium Linear Sconce Instruction Manual

ASSEMBLY INSTRUCTIONS

KW 2702 Avant Medium Linear Sconce

Avant Medium Linear Sconce
Item # KW 2702
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.
**WARNING*** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE:** CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND INSTALLATION ARE FINAL.

1. Carefully remove all parts from the box.

2. Remove the shade (J) from fixture body (F) by loosening side screws (I).

3. Remove the mounting plate (C) from fixture body (F) by loosening ball nuts (H).

4. Drill 4 holes on the wall and make sure the hole distance will match to the holes on the fixture body (F).

5. Knock the anchors (B) into the wall holes.

6. Affix mounting plate (C) onto the outlet box and secure with mounting screws (E).

7. Connect the hot wire (BLACK) from the fixture to the hot wire from the outlet box (usually BLACK). Fasten them together with a plastic wire connector (A) provided and wrap the connection with electrical tape.

8. Connect the neutral wire (WHITE) from the fixture to the wire from the outlet box (usually WHITE).
   DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.

9. Connect ground wire from the fixture (bare copper) to ground wire from the outlet box (usually green or copper in color).
   IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.

10.  Attach the fixture body (F) onto the mounting plate (C). Let screws (D) pass through the holes on the fixture body, then secure with ball nuts (H).

11. Secure the screws (G) to the anchors (B).

12. Insert bulbs (not included) into the sockets.

13. Attach the glass diffuser (K) to the shade (J) and secure by bending the metal tabs.

14. Attach the shade (J) to fixture body (F) and secure with side screws (I).

15. Installation is complete, turn on power at fuse or circuit breaker.
    ***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>