George Kovacs P5352-1-084-L 24 Inch 1 Light Brushed Nickel LED Vanity Light Instruction Manual
- June 12, 2024
- GEORGE KOVACS
Table of Contents
P5352-1-084-L 24 Inch 1 Light Brushed Nickel LED Vanity Light
Instruction Manual
INSTALLATION INSTRUCTIONS FOR P5352-X-084-L
For Wall Mounted Fixture
P5352-1-084-L 24 Inch 1 Light Brushed Nickel LED Vanity Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARATION
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to misplace any small parts necessary for installation
MOUNTING THE FIXTURE (Fig. 1)
-
Secure mounting plate (B) to junction box (A) (not included) using mounting screws (E) (Size: #8-32*1/2”L). The side of the mounting plate marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2) -
Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box (A) has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided.
-
Tuck wire connections neatly inside the junction box.
FINISHING THE INSTALLATION (Fig. 1) -
Place fixture body (G) to mounting plate (B) and secure with screws (D).
Your installation is now complete. Return power to the junction box and test
the fixture.
CAUTION / ATTENTION: When handling the fixture, do not apply pressure to
the LEDs. Hold the fixture by the base or fixture body only.
IMPORTANT : Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switch.
Fig. 1
Mounting Plate Set #:
A-021-140113 for P5352-1-084-L/P5352-2-084-L
-Mounting plate (B)
-Ground screw (F)
-Mounting screw (E)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>