LUXLOGIC LIGHTING 100W LED High Bay Light Instruction Manual
- June 12, 2024
- LUXLOGIC LIGHTING
Table of Contents
LUXLOGIC LIGHTING 100W LED High Bay Light
Scope of Application
With unique high-brightness SMD chips, high-purity aluminium heats sinks, high-efficiency constant current and constant voltage power drivers, this LED high bay light is designed for high quality lighting for gas stations, exhibition halls, factories, highway toll stations, workshop, warehouses, stadiums, supermarkets and similar applications, etc.
Installation Steps
① Install the O-rings and screw tight.
② Screw in the M3, tightening until flush.
-
Install the cable/pendant
-
Install the fixture and wiring
-
Adjust the angle as required, then tighten the set screws securely to protect against loosening.
Technical Parameters
| CCT | 2700-6500K | Power Factor | >0.95 |
|---|---|---|---|
| CRI | Ra>70 / Ra>80 | Working Life | 50,000hours |
| IP Grade | IP 65 | Rated Voltage | AC 100-240V 2nv-, |
50/60Hz
Beam Angle| 60° /120°
(100/150/200/240W)| Lamp Luminous Flux| 160LM/W±5%
30/°60° /90° /120°
(300/400/480W)| Working Temperature| -40°C ~ 6o°C
Lamp Power| Lamp Size (mm)| Lamp Luminous Flux| Net Weight (kg)
---|---|---|---
100W| 429429159mm| 16,000LM| 4.5±5%
150W| 429429159mm| 24,000LM| 4.5±5%
200W| 429429159mm| 32,000LM| 5.3±5%
240W| 429429159mm| 38,400LM| 5.3±5%
300W| 429429225mm| 48,000LM| 7.1±5%
400W| 429429225mm| 48,000LM| 7.4±5%
480W| 429429225mm| 76,800LM| 7.4±5%
Trouble Shooting
- Do not disassemble light without authorization.
- Pease report any abnormalities to the manufacturer.
| Problem | Possible Cause | Solutions |
|---|---|---|
| LEDs stop working | The power line/plug is improperly connected. | Reconnect the |
power cable/plug.
Power failure.| Check the circuit.
Fault with LED driver.| Replace with new driver.
Damage to LED chips.| Replace with new LEDs board.
LEDs flash on and off| The output of the driver is abnormal.| Replace with new
driver.
The LED chip breaks down.| Replace with new LED board.
Voltage instability.| Power-off and check the power supply.
Warning
Follow The Installation Instructions
|
Certified Installer
|
No Live Line Work
---|---|---
Power-Off In Accident
|
Use Original Parts
|
Use Waterproof Wiring
Not Suitable For Underwater Use
| -40°C~60°C Working Temperature
|
Keep Away From Chemical
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>