Itian V11A Cell Phone and Watch Power Bank User Manual
- June 12, 2024
- Itian
Table of Contents
Itian V11A Cell Phone and Watch Power Bank
Product Information
This product is designed to comply with Part 15 of the FCC Rules. It operates as a transmitter and receiver device. The equipment has been tested and found to meet the FCC radiation exposure limits for an uncontrolled environment. It should be operated with a minimum distance of 20cm between the radiator and the user’s body to ensure compliance with the regulations. Any modifications or changes not approved by the responsible party could result in the user losing their authority to operate the equipment.
Product Usage Instructions
- Ensure that the device is installed and operated in accordance with the instructions provided in the user manual.
- Maintain a minimum distance of 20cm between the radiator and your body during operation.
- Avoid using this device in conjunction with any other antenna or transmitter to prevent interference.
- Do not modify or make any changes to the equipment withoutexplicit approval from the responsible party.
- If you experience any interference or undesired operation, try adjusting the positioning of the device or contact customer support for assistance.
Thank you for purchasing and using this product! Please read this operation instruction carefully before using this product.
Attention
- Do not squeeze or collide vigorously.
- Please do not disassemble or put into the fire or water in the powered state to avoid short circuit and leakage.
- Please do not use in severe high temperature, high humidity or corrosive environment to avoid damage to the circuit and leakage.
- Please do not place magnetic cards with magnetic stripes or chips (ID cards, bank cards, etc.) on the wireless charging board to avoid magnetic card failure.
- Please do not place metal (coins and other metal objects) on the wireless charging pad while charging. to avoid heat damage.
Specifications
-
Battery Capacity 5000mAh
-
Lightning Input 5V-=2.0A / 9V=2A
-
Type C Input & Output 5V:=2.5A / 9V=2A / 12V=1.67A
-
Built-in Cable Output 5Vr=2.5A / 9V=-2A / 12V=1.67A
-
Apple Watch Output Power 3W
-
for Fast charging mode, 18W or above power adapter is required as its power source.
Product Detail Part
Product Description
- 5000mAh polymer battery.
- It can charge cell phone and Apple Watch at the same time.
- When using wired charging alone, the output is 20W fast charging and supports PD/QC3.0 fast charging protocol.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.