smania SU-35 RC Fighter Jet Air Jet Instructions

smania SU-35 RC Fighter Jet Air Jet

PACKAGE CONTENT

• Jet
• Remote controller
• LED lights
• Landing gear
• Replacement propellers
• Charging cable

TECHNICAL SPECIFICATIONS

• Material: EPP foam, ABS
• Airplane size: 8 × 24,8 × 34,2 cm
• Battery: 3,7 V, 150 mAh rechargeable
• Remote battery: 2 × 1,5 V AA (not included)

COMPONENTS

1. Front landing gear slot
2. Battery compartment
3. ON/OFF switch
4. LED light power connectors
5. Propellers
6. Rear landing gear slot

BEFORE THE FIRST FLIGHT

• Remove the battery from its compartment and charge it with the included charging cable. Connect the battery to the cable and connect the cable to your computer or phone charger. The red light is on while the battery is charging. When the battery is fully charged, the light turns off.
• Insert the fully charged battery back into the battery compartment and connect it to the plane (using the connector inside the battery compartment). Close the compartment cover.
• If you want to use the plane’s landing gear, put it into the corresponding landing gear slots. TIP: the landing gear with only one wheel goes in the front.
• Remove the battery compartment cover on the controller and insert two AA batteries (not included in the package). Mind the polarity. Once the batteries are inserted, close the battery compartment cover.
• To install the LED lights, remove the protective strips on the lights and stick them to the plane anywhere you want. Connect the power strips to the LED light power connectors on the plane. Refer to the components diagram for more info.

FLYING THE PLANE

• Turn ON the controller by pressing the round button in the middle. A red light will turn on indicating that the controller is turned ON. This button is also used to turn OFF the controller.
• Then, turn ON the airplane by flipping the ON/OFF switch on the bottom of the plane to the ON position. A red light will come on when the plane is ON and connected to the controller.
• The plane can start from the ground (if it has the landing gear installed), or you can throw it
• To start from the ground, make sure that the landing gear is installed, then place it onto a flat and smooth surface outside.
• With both the plane and the controller turned ON, slowly press the accelerator forward (left lever). The plane will start moving, use the right lever for steering (both on land and in the air). It might take a few meters to take off, so make sure there’s enough space for the plane to maneuver on the ground.
• You can also throw the plane like a paper plane to make it fly. Make sure that the propellers are spinning at full throttle before throwing to maximize lift and achieve easy flight. When throwing the plane, be wary of the spinning propellers and don’t put your fingers near them. Also be aware of your surroundings.

TROUBLESHOOTING

• If the propellers get damaged, please replace them with the spare propellers included in the package. Check the markings on the propellers to see which one goes on which side. The A1 propeller should be on the left side of the plane and the B1 should be on the right side.
• If the body gets damaged, use tape to repair it. Do not fly the plane if it’s damaged and you have not repaired it beforehand.

WARNINGS

• Do not bend the wings and the landing gear.
• Only fly outdoors and make sure there are no power lines or obstructions nearby.
• Do not fly the plane into people, traffic, or animals.
• Children should only operate the plane under adult supervision
• Remove the batteries from the plane and the remote control and turn both OFF when not in use.
• Only use the included charging cable to charge the battery.

WARRANTY

The warranty is valid for 24 months. You can claim it from DFVU d.o.o. družba za posredništvo, Liparjeva 6a, 1234 Mengeš, Slovenia, for a replacement product or a refund. Send us your order number and purchase date in the email, which is available by clicking on our logo in the bottom right corner. The product has a lifetime of 24 months from the date of collection.

| WEEE disposal and recycling symbol. The WEEE symbol is attached to the product in compliance with the EU directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE).
It is intended to deter the improper disposal of this product and to
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>