rabalux 75015-LED Medina Motion Sensor User Manual

June 12, 2024
RABALUX

rabalux 75015-LED Medina Motion Sensor

rabalux-75015-LED-Medina-Motion-Sensor-product

Product Information

  • Switch on time: 10 seconds
  • Max. bulb wattage: 1.5W energy-efficient light source
  • IP protection: IP20
  • Network voltage: 230V~50Hz
  • Light intensity for motion sensor activation: < 25 lux

Product Usage Instructions

  1. Ensure the Medina Motion Sensor is properly installed and positioned.
  2. Connect the sensor to a power source with a network voltage of 230V~50Hz.
  3. Verify that the bulb wattage does not exceed 1.5W to ensure energy efficiency.
  4. Make sure the IP protection rating is suitable for the intended use (IP20).
  5. The motion sensor will activate when the light intensity falls below 25 lux.
  6. The switch-on time of the sensor is set to 10 seconds.

Please refer to the user manual for further details and specific instructions for your region.

Usage Instructions

  • Do not install the sensor too high. If the sensor is installed too high, the on/off switching can be negatively affected. Optimal detection is achieved when the sensor is installed at a height of approximately 2.5 metres.
  • The ambient temperature considerably influences the detection area. Since the sensor detects differences in temperature, the detection area may be significantly greater in winter than in summer.
  • Do not install the sensor above trees or bushes. The movement of vegetation can result in unnecessary switching on and off.
  • The sensitivity of the sensor is greater in a lateral direction, while it may be less when the movement is towards/away from the sensor.
  • The sensor detection range can also be adjusted manually by covering the sensor lens to the desired angle. (Means of covering the lens is not included with the light fitting.)
  • Security notice. Warning, please leave adjustment of the sensor to an expert.
  • It is forbidden to dismantle or modify the electrical connection of this light fitting with motion sensor.
  • Before fitting, ensure there is no electrical current by switching off the safety fuses. Only ever use a bulb of the power output recommended by the manufacturer.
  • Override Function:  Quick switch ON/OFF 3 times within 2sec to override sensor function. Lights will switch on all the time. Power off and on again to recover sensor function.
  • Initialization: After power on, the sensor automatically turns on light at 100% brightness. After 10sec, it turns off the light. During the initialization, the sensor is not able to detect movement.

Sensor Technical Data

  • Detection angle: 120°
  • Detection range: 6 m
  • Switch on time: 10 seconds
  • Max. bulb wattage: 1,5W energy efficient light source.
  • IP protection: IP20
  • Network voltage: 230V~50Hz
  • Light intensity for motion sensor activation: < 25 lux

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals