delta PS1000 Premium Shelving Kit Instruction Manual
- June 12, 2024
- Delta
Table of Contents
delta PS1000 Premium Shelving Kit
Assembly instructions
Parts
- A x2 — Aluminum Slotted Upright
- B x4 — Cosmetic Cover
- C x4 — Upright End Caps
- D x4 — Arms* (x6 PS1003)
- E x4 — Arm End Caps* (x6 PS1003)
- F x8 — Wall Screws
- G x8 — Shelf Screw* (x12 PS1003)
- H x8 — Drywall Anchors
- I x1 — Connector Alignment Piece
- J x2 — Shelf* (Not included with all sets)
Tools Required
Hand Drill
1/8″ (3mm) drill bit for attaching to wood studs 5/16″ (8mm) drill bit for
attaching to concrete walls Magnetic Phillips Drill Bit
Spirit Level
Tape Measure
Way of locating studs within the wall (see hardware store for advice)
- Place uprights against located stud on the wall and mark the location for holes. Use a spirit level to make sure it is vertically aligned. Ensure the second upright is horizontally aligned and level with the rest upright, when marking locations for holes. Drill 1/8″ (3mm) pilot holes. Then secure the uprights to the wall using the screws provided.
NOTE: If mounting to a drywall, use the included drywall anchors (Part H). Drywall anchors require 5/16″ (8mm) pilot holes. Once holes are drilledgently tap drywall anchors into place, then secure uprights using screws provided. *Installing into wood studs is the recommended method.
IMPORTANT SAFETY NOTE
Beware of drilling into electrical wire or pipes within wall!
WARNING: Do not allow children to play or hang from Shelving Kit. Maximum weight 18 kg (40 lbs) per shelf arm, evenly distributed on properly installed rack into studs. Installing into a drywall will reduce the weight capacity
-
Choose desired positions for arms (Part D). Insert into place, by hooking into the slot.
Once a position is confirmed, measure the distance above, between, and below each arm. This will give you the size for the cosmetic cover. (FIGURE 1) -
Use scissors or utility knife to cut cosmetic cover (Part B) to the determined height and insert into upright. Slide or press the cosmetic pieces into the groove at the front of the upright.
-
Assemble shelves (Part J) using shelf screws (Part G)
-
Assemble upright end caps (Part C) to uprights. (FIGURE 1) Assemble arm end caps (Part E) to arms. (FIGURE 2)
Expandable Option
When aligning multiple racks vertically, use the included connector alignment piece (Part I). First, slide the lower half of the connector alignment piece into the lower upright. Then slide the upper upright onto the top half of the connector alignment piece.
Delta Cycle Corporation
- 36 York Avenue, Randolph, MA 02368 USA
- 800-474-6615
- www.designbydelta.com.
Service: Please do not return to the store; for immediate response email service@designbydelta.com.
Assembly video
Visit designbydelta.com/downloads.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>