ZENTY ZT-146 Modular Matrix 1080P 60Hz HDBaseT Input Card User Manual
- June 12, 2024
- ZENTY
Table of Contents
Zenty | Professional A/V Solution Provider
User Manual [V1.0]
Modular Matrix 1080P 60Hz HDBaseT Input Card 328ft.
ZT-146 | ZT-MINB1080
ZENTY ®
9807 EMILY LANE
STAFFORD, TX 77477
844-200-1945
SUPPORT@ZENTY.COM
1. Introduction
This is a 1-card 1-port 1080P HDBaseT input card which is to be used on the Zenty chassis, including 9×9, 16×16, 18×18 and 36×36. It supports scaling function by the DIP switch. It also supports bidirectional IR and the RS232 transmission. It’s using the HDBaseT technology, so it can support PoC for the HDBaseT transmitters. The distance can up to 328ft (100m) for 1080P.
2. Features
- Output resolution up to 1080P
- Supports scaling function by the 8-PIN DIP switch
- Supports HDBaseT input
- Distance up to 100m/330ft at 1080P over single Cat6/7
- Supports RS232, bi-directional IR
- PoC (Power over Cable) function
3. Specifications
Audio and Video
Inputs| 1 x HDBaseT In: RJ-45
Latency| 15 – 30ms
Audio Formats| 2ch PCM, DTS-HD Master, TrueHD
Video Resolutions and Cable Distances| 720P 60Hz 12-bit: Up to 330ft. / 100m
1080P 30Hz 12-bit: Up to 330ft. / 100m
1080P 60Hz 12-bit: Up to 330ft. / 100m
Standards / Protocol| HDCP 1.4
Maximum Pixel Clock| HDMI: 296Mhz
Communication and Control
HDBaseT| HDMI, HDCP 1.4, PoH / PoC, Bi-directional IR, RS232
IR| 1 x IR RX (3.5mm), 1 x IR TX (3.5mm)
RS232| 3-Pin phoenix connector
Power
Power Supply| Internal to / from matrix
PoH / PoC| 12V
Consumption| 3W with no PoC to transmitter
6W with PoC to transmitter
4. PoC Setup
There’s a 4-pin black DIP on the HDBaseT card, it’s able to set up the POC
function as 12V, 24V and POC function off.
Set POC to 12V: Have the DIP switch A & B up, and the C * D to down
position.
Set POC to 24V: Have the DIP switch A & C down, and the B & D to up position.
Set POC to 24V: Have the DIP switch A & C down, and the B & D to up position.
POC function OFF: Have the 4-pin DIP switch set to the middle position.
5. 8-Pin DIP Switch Setup
6. Maintenance
Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner, or benzine to clean.
7. Warranty
If your product does not work properly because of a defect in materials of workmanship, our company (referred to as “the warrantor”) will, for the length of the period indicated as below, “Parts and Labor (5) Years”, which starts with the date of original purchase (“Limited Warranty period”), at its option either (a) repair your product with new or refurbished parts, or (b) replace it with a new or a refurbished product. The decision to repair or replace will be made by the warrantor.
During the “Labor” limited warranty period, there will be no charge for labor. During the “Parts” warranty period, there will be no charge for parts. You must mail-in your product during the warranty period. This Limited Warranty is extended only to the original purchaser and only covers products purchased as new. A purchase receipt or other proof of original purchase date is required for Limited Warranty service.
8. Mail-In Service
When shipping the unit, carefully pack and send it prepaid, adequately insured, and preferably in the original carton. Include a letter detailing the complaint and provide a day time phone and/or email address where you can be reached.
9. Limited Warranty Limits and Exclusions
This Limited Warranty ONLY COVERS failures due to defects in material or workmanship, and DOES NOT COVER normal wear and tear or cosmetic damage. The Limited Warranty ALSO DOES NOT COVER damages which occurred in shipment, or failures which are caused by products not supplied by warrantor, or failures which result from accidents, misuse, abuse, neglect, mishandling, misapplication, alteration, faulty installation, set-up adjustments, mis- adjustment of consumer controls, improper maintenance, power line surge, lightning damage, modification, or service by anyone other than a Factory Service center or other Authorized Servicer, or damage that is attributed to acts of God.
THERE ARE NO EXPRESS WARRANTIES EXCEPT AS LISTED UNDER “LIMITED WARRANTY COVERAGE”. THE WARRANTOR IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTAIL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. (As examples, this excludes damages for lost time, cost of having someone remove or re-install an installed unit if applicable, travel to and from the service, loss of or damage to media or images, data or other recorded content. The items listed are not exclusive, but are for illustration only.) PARTS AND SERVICE, WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY, ARE YOUR RESPONSIBILITY.
WWW.ZENTY.COM
9807 EMILY LANE
STAFFORD, TX 77477
844-200-1945
SUPPORT@ZENTY.COM
SALES@ZENTY.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>