ZENTY ZT-147 Modular Matrix 1080P 60Hz HDBaseT Output Card User Manual
- June 12, 2024
- ZENTY
Table of Contents
ZENTY ZT-147 Modular Matrix 1080P 60Hz HDBaseT Output Card
INTRODUCTION
This is a 1-card 1-port 1080P HDBaseT output card which is to be used with the Zenty series chassis including 9×9, 16×16, 18×18, and 36×36, it supports bi- directional IR and the RS232 transmission. These outputs card also can support the video wall function, and scaling/slipping function by the 8-PIN DIP switch. It’s using HDBaseT technology, so it can support POC for the HDBaseT receivers. The distance can be up to 328ft (100m) for 1080P.
FEATURES
- Output resolution up to 1080P
- Supports HDBaseT output
- Distance up to 100m/330ft at 1080P over single Cat6/7
- Supports RS232, bi-directional IR
- Supports seamless switching
- Supports video wall function
- Supports Scaling and flipping function by the 8-PIN DIP switch
- PoC (Power over Cable) function
SPECIFICATIONS
Audio and Video
Outputs| 1 x HDBaseT out: RJ-45
Latency| 15 to 30ms
Audio Formats| 2ch PCM: DTS-HD Master, TrueHD, no ARC, no
Dolby Atmos
Video Resolutions and distance (STP CAT6)| 720P @ 60Hz 12-bit: 328ft / 100m
1080P @ 30Hz 12-bit: 328ft / 100m
1080P @ 60Hz 12-bit: 328ft / 100m
Standards / Protocols| HDCP 1.4
Maximum Pixel Clock| HDMI: 296Mhz
Communication and Control
HDBaseT| HDMI, HDCP 1.4, EDID, PoH, PoC, Bi-directional
IR, RS232
IR| 1 x IR (3.5mm), 1 x IR TX (3.5mm)
RS232| 3-Pin Phoenix connector, cards to receivers not
to matrix
Power
Power Supply| Internal to/from the matrix
PoH / PoC| 12V
Consumption| 3W with no PoC to the transmitter
6W with PoC to the transmitter
POC SETUP
There’s a 4-pin black DIP on the HDBaseT card, it’s able to set up the POC function as 12V, 24V, and POC function off. Set POC to 12V: Have the DIP switch A, and B up, and the C, and D to the down position.
DIP SWITCH SETTINGS
MAINTENANCE
- Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner, or benzene to clean.
WARRANTY
If your product does not work properly because of a defect in materials or
workmanship, our company (referred to as “the warrantor”) will, for the length
of the period indicated below, “Parts and Labor (5) Years”, which starts with
the date of original purchase (“Limited Warranty Period”), at its option
either (a) repair your product with new or refurbished parts, or (b) replace
it with a new or a refurbished product. The decision to repair or replace will
be made by the warrantor.
During the “Labor” limited warranty period, there will be no charge for labor.
During the “Parts” warranty period, there will be no charge for parts. You
must mail in your product during the warranty period. This Limited Warranty is
extended only to the original purchaser and only covers products purchased as
new. A purchase receipt or other proof of original purchase date is required
for Limited Warranty service.
MAIL-IN SERVICE
- When shipping the unit, carefully pack and send it prepaid, adequately insured, and preferably in the original carton. Include a letter detailing the complaint and provide a daytime phone and/or email address where you can be reached.
Limited Warranty Limits and Exclusions
This Limited Warranty ONLY COVERS failures due to defects in material or
workmanship and DOES NOT COVER normal wear and tear or cosmetic damage. The
Limited Warranty ALSO DOES NOT COVER damages which occurred in shipment, or
failures which are caused by products not supplied by the warrantor, or
failures which result from accidents, misuse, abuse, neglect, mishandling,
misapplication, alteration, faulty installation, set-up adjustments,
misadjustment of consumer controls, improper maintenance, power line surge,
lightning damage, modification, or service by anyone other than a Factory
Service Center or other Authorized Servicer, or damage that is attributed to
acts of God.
THERE ARE NO EXPRESS WARRANTIES EXCEPT AS LISTED UNDER “LIMITED WARRANTY
COVERAGE”. THE WARRANTOR IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS
WARRANTY. (As examples, this excludes damages for lost time, cost of having
someone remove or re-install an installed unit if applicable, travel to and
from the service, and loss of or damage to media or images, data or other
recorded content. The items listed are not exclusive, but are for illustration
only.) PARTS AND SERVICES, WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY, ARE
YOUR RESPONSIBILITY.
- WWW.ZENTY.COM.
- 9807 EMILY LANE
- STAFFORD, TX 77477
- 844-200-1945
- SUPPORT@ZENTY.COM.
- SALES@ZENTY.COM.
ZENTY ®
- 9807 EMILY LANE
- STAFFORD, TX 77477
- (844)200-1945
- SUPPORT@ZENTY.COM.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>