ICOM IC-F1000 Series VHF Commercial Transcivers Instructions

ICOM IC-F1000 Series VHF Commercial Transcivers

Product Information

The product is a VHF/UHF transceiver manufactured by Icom Incorporated. It comes in three types: IC-F1000/F2000 (non-display type), IC-F1000S/F2000S (simple type with 4-key), and IC-F1000T/F2000T (10-key type). The transceiver is designed for communication purposes and is compatible with various accessories and options.

Batt ery Packs:

• BP-278: Voltage: 7.2 V, Capacity: 1130 mAh (minimum) – 1190 mAh (typical)
• BP-279: Voltage: 7.2 V, Capacity: 1485 mAh (minimum) – 1570 mAh (typical)
• BP-280: Voltage: 7.2 V, Capacity: 2280 mAh (minimum) – 2400 mAh (typical)

Battery Life:
The battery life varies depending on the frequency band. When the power save function is turned ON, the estimated battery life is as follows:

• VHF: 10 hours (TX:RX: standby = 5:5:90)
• UHF: 10 hours (TX:RX: standby = 5:5:90)
• VHF: 14 hours (TX:RX: standby = 5:5:90)
• UHF: 14 hours (TX:RX: standby = 5:5:90)
• VHF: 20 hours (TX:RX: standby = 5:5:90)
• UHF: 20 hours (TX:RX: standby = 5:5:90)

Chargers:
The product supports various chargers, including D battery packs, D DC cables, and the BC-213 desktop charger. These chargers are used for charging the battery packs.

Others:
The product offers additional accessories such as speaker microphones, headsets, ptt switch cables, adapter cables, and different types of microphones (ear-hook, neck-arm, throat). These accessories provide convenience and hands-free operation.

Antennas:
The product supports antennas for better signal reception and transmission.

Product Usage Instructions

1. Battery Usage:
   • Choose the appropriate battery pack based on voltage and capacity requirements.
   • Ensure the battery is properly installed in the transceiver.
   • Charge the battery using the supplied battery charger or compatible chargers.
   • Refer to the user manual for detailed instructions on battery charging and maintenance.
2. Transceiver Operation:
   • Familiarize yourself with the panel description and function display of the transceiver.
   • Connect the antenna to the antenna connector for optimal signal reception and transmission.
   • Use the LED indicator to monitor the status of the transceiver. Green indicates normal operation.
   • If using a speaker microphone, connect it to the speaker microphone jack for convenient operation.
   • Adjust the microphone gain before use for optimal audio output.
3. Accessories Usage:
   • Refer to the user manual for specific instructions on using accessories such as headsets, ptt switch cables, and adapter cables.
   • Adjust the microphone and VOX gain before use for proper functionality.
   • Ensure compatibility with the transceiver version before using the accessories.
4. Maintenance:
   • Follow the recommended maintenance procedures outlined in the user manual.
   • Keep the transceiver and accessories clean and free from dust and moisture.
   • Refer to the IP67 requirements for dust-tight and waterproof protection when using specific accessories.

Note: Some options may vary depending on the country. Contact your dealer for more details and availability.

Thank you for choosing this Icom product.
READ ALL INSTRUCTIONS carefully and completely before using this product.

SUPPLIED ACCESSORIES

1. Battery pack
2. Battery charger
3. Belt clip
4. Power adapter (for the battery charger)
5. Flexible antenna

NOTE: Not supplied, or the shape is different depending on the transceiver version.

PANEL DESCRIPTION

The illustration is for the 10-key type transceivers.

There are 3 types of transceivers in the IC-F1000 and IC-F2000 series.

• IC-F1000/F2000: Non-display type (Basic type)
• IC-F1000S/F2000S: Simple type (4-key type) [LCD + 4 keys (P0 ~ P3)]
• IC-F1000T/F2000T: 10-key type [LCD + 4 keys + 10-key Pad]

About the LED Indicator

• Lights red while transmitting.
• Lights green while receiving a signal, or when the squelch is open.
• Lights or blinks orange when the matching 2-Tone or 5-Tone is received, depending on the presetting.
• You should charge the battery when the indicator slowly blinks green.
• You must charge the battery when the indicator blinks green fast.

About the Speaker microphone jack

CAUTION:
Only when the jack cover or the optional HM-222HLWP, HS-94LWP, or HS-95LWP is attached, the transceiver meets IP67 requirements for dust-tight and waterproof protection.

FUNCTION DISPLAY

1. SIGNAL STRENGTH INDICATOR
   Displays the relative receive signal strength level.

2. LOW POWER ICON
   Displayed when low output power is selected.

   • When the battery charge decreases to a set level, low power is automatically selected.

3. AUDIBLE ICON

   • Displayed when the channel is in the Audible (unmuted) mode.
   • Displayed when a matching 2-Tone or 5-Tone is received.

4. COMPANDER ICON
   Displayed when the Compander function is ON.

5. SCRAMBLER ICON
   Displayed when the Voice Scrambler function is ON.

6. BELL ICON
   Displayed or blinks when a matching 2-Tone or 5-Tone is received, depending on the presetting.

7. SCAN ICON
   Displayed or blinks while scanning.

8. KEY LOCK ICON
   Displayed when the Key Lock function is ON.

9. BATTERY INDICATOR

   • Displays the remaining battery charge.
   • Blinks when the battery charge decreases to a set level.

10. ALPHANUMERIC READOUT
    Displays messages such as channel text.

BATTERY CHARGING

Not supplied, or the shape is different, depending on the transceiver version.

Rapid charging the supplied BC-213

• The BC-213 desktop charger rapidly charges the Li-ion battery pack.
• The BC-213 is used with a power adapter or the CP-23L cigarette lighter cable (purchased separately).

Charging time of the BP-279

• Approximately 2 to 3 hours

CAUTION:
STOP charging, if the charge indicator lights orange and green alternately.

NOTE:
Charge the battery within the specified temperature range of +10°C ~ +40°C (+50°F ~ +104°F). Otherwise, the charging time will be longer, but the battery will not reach a full charge. While charging, at a point after the temperature goes out of the specified range, the charging will automatically stop.

Rapid charging the BC-214
The BC-214 multi-charger (purchased separately) can simultaneously charge up to 6 Li-ion battery packs. The BC-214 is used with the BC-157S ac adapter (purchased separately) or the OPC-656 dc power cable (purchased separately).

Charging time of the BP-279

• Approximately 2 to 3 hours

TIP:
For more information about Icom accessories, please read the “OPTIONS” printed on the reverse side of this instruction sheet.

BASIC OPERATION

Turning ON the transceiver

NOTE:
Before using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. See the instructions on page 2.

Rotate [VOL] to turn ON the transceiver.

Receiving and Transmitting

CAUTION:
DO NOT transmit without an antenna.

Receiving:

1. Rotate [ROTARY SELECTOR], or push one of the memory channel keys, [MR-CH 1] ~ [MR-CH 4], to select a channel.
2. When receiving a call, adjust the audio output level to a comfortable listening level.

Transmitting:

1. Wait until the channel is clear to avoid interference.
2. While holding down [PTT], speak at your normal voice level.
3. Release [PTT] to receive.

IMPORTANT:
To maximize the readability of your signal:

1. After pushing [PTT], pause briefly before you start speaking.
2. Hold the microphone 5 ~ 10 cm (2 ~ 4 inches) from your mouth, then speak at your normal voice level.

OPTIONS

BATTERY PACKS

BP-278/BP-279/BP-280 battery pack

BP-278

| ****

7.2 V

| 1130 mAh

(minimum) 1190 mAh

(typical)

| VHF| 10 hours
UHF| 10 hours

BP-279

| ****

7.2 V

| 1485 mAh

(minimum) 1570 mAh

(typical)

| VHF| 14 hours
UHF| 14 hours

BP-280

| ****

7.2 V

| 2280 mAh

(minimum) 2400 mhA

(typical)

| VHF| 20 hours
UHF| 20 hours

When the power save function is turned ON, and the operating periods are calculated under the following conditions.

• TX: RX: standby = 5: 5: 90

CHARGERS

• BC-213 desktop charger + BC-123S ac adapter
  To rapid charge a single battery pack.

• BC-214 multi charger + BC-157S ac adapter
  To rapid charge up to 6 battery packs.

DC CABLES

• CP-23L cigarette lighter cable
  Use when charging the battery pack from a 12 V cigarette lighter socket. (Use with the BC-213)

• OPC-656 dc power cable
  Use with a 13.8 V power source instead of the power adapter. (Use with the BC-214)

ANTENNAS

FA-SC25V/FA-SC55V/FA-SC62V/FA-SC63V vhf antennas

• FA-SC25V: 136 ~ 150 MHz
• FA-SC55V: 150 ~ 174 MHz
• FA-SC62V: 150 ~ 160 MHz
• FA-SC63V: 155 ~ 165 MHz

FA-SC26VS/FA-SC27VS/FA-SC56VS/FA-SC57VS vhf stubby antennas

• FA-SC26VS: 136 ~ 144 MHz
• FA-SC27VS: 142 ~ 150 MHz
• FA-SC56VS: 150 ~ 162 MHz
• FA-SC57VS: 160 ~ 174 MHz

FA-SC61VC vhf cut antenna

• FA-SC61VC: 136 ~ 174 MHz

FA-SC25U/FA-SC57U/FA-SC72U/FA-SC73US uhf antennas

• FA-SC25U: 400 ~ 430 MHz
• FA-SC57U: 430 ~ 470 MHz
• FA-SC72U: 470 ~ 520 MHz
• FA-SC73US: 450 ~ 490 MHz

FA-SC26US uhf stubby antenna

• FA-SC26US: 400 ~ 450 MHz

FA-SC01U/FA-SC02U uhf antenna

• FA-SC01U: 350 ~ 400 MHz
• FA-SC02U: 330 ~ 380 MHz

FA-SC61UC uhf cut antenna

• FA-SC61UC: 380 ~ 520 MHz

OTHERS

• MB-130 mobile bracket
  Mounts the BC-213 desktop charger on a variety of places in a vehicle.

• MB-133 belt clip

• HM-158LA/HM-159LA/HM-222HLWP*

  • speaker microphone
    Combination speaker-microphone that provides convenient operation while the transceiver is hanging on your belt.

Adjust the microphone gain before use.

High audio output is only usable with transceivers that support the function. (With a “U” mark on the serial number label)

HM-153LA/HM-166LA earphone-microphone
Ideal for hands-free operation. Clip the HM-153LA or HM-166LA (with integrated PTT switch) to your lapel or breast pocket.

Adjust the microphone gain before use.

HS-94/HS-95/HS-97 headset
+ VS-4LA ptt switch cable/OPC-2004LA adapter cable

• HS-94: Ear-hook type
• HS-95: Neck-arm type
• HS-97: Throat microphone
• VS-4LA: To connect to headsets
• OPC-2004LA: To connect to headsets for VOX operation

Adjust the both microphone and VOX gain before use.

HS-94LWP/HS-95LWP headset

• HS-94LWP: Ear-hook type
• HS-95LWP: Neck-arm type

Adjust the both microphone and VOX gain before use.

Some options may not be available in some countries. Ask your dealer for details.

Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries.

All other products or brands are registered trademarks or trademarks of their respective holders.

Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan.

Printed in Japan
© 2014–2021 Icom Inc.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>