beamZ FLOOD36UV LED UV Flood Light User Guide
- June 4, 2024
- beamZ
Table of Contents
beamZ FLOOD36UV LED UV Flood Light
UNPACKING INSTRUCTIONS
CAUTION
Immediately upon receiving the product, carefully unpack the carton, check
the contents to ensure that all parts are present, and have been received in
good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself
shows signs of mishandling. Save the package and all packing materials. In the
event that the product must be returned to the factory, it is important that
the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached
room temperature.
POWER SUPPLY
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
WARNING
Always connect the unit to a protected circuit (circuit breaker or fuse).
Make sure the unit has an appropriate electrical ground to avoid the risk of
electrocution or fire.
RIGGING
The unit may be set up on a stable and even surface. By means of the fixing facilities of the baseplate, the unit can also be mounted upside down to a truss, see below picture. For fixing, certified clamps with correct save working load are required. According to the figure, the quick lock bolts of the omega brackets are placed into the openings provided in the base plate and turned clockwise until they lock (to the stop). The mounting place must be of sufficient stability and be able to support a weight of 10 times of the unit’s weight. Secure the unit with a safety cable so that it cannot fall down. When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let the installation checked out by an authorized dealer !
DMX512 CONTROL
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
CAUTION At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
CONTROL MENU
| |
---|---|---
| A000- Axxx| DMX address setting
| 4 Ch| DMX Channel mode
| 8Ch|
| CL01- CL09| Constantly bright area selection.
CL09 is constantly bright.
| CC01- CC99| Jump mode, the value is
larger, the speed is faster.
| EE01- EE99| Pulse mode, the value is
larger, the speed is faster.
| FF01- FF99| Fading mode, the value is
larger, the speed is faster.
| ST01- ST99| Strobe change, the value is
larger, the speed is faster.
| Sou1| Sound control jump mode
| Sou2| Sound control pulse mode
| Sou3| Sound control strobe mode
| Sou4| Full effect control mode
| R000- R255| Adjust brightness 1st segment, 0-
1 0 0%
| G000- G255| Adjust brightness 2nd segment, 0-100%
| B000- B255| Adjust brightness 3rd segment, 0-100%
| U000- U255| Adjust brightness 4th segment, 0- 1 0
0%
DMX CHANNELS
4 CHANNELS
| | |
---|---|---|---
1| Dimmer| 000- 255| 1 st **segment,
0-100%
2| | 000- 255| 2 nd ****segment, 0-100%
3| | 000- 255| 3 rd ****segment, 0-100%
4| | 000- 255| 4 th ****segment, 0-100%**
8 CHANNELS
| | |
---|---|---|---
1| Master dimmer| 000- 255| Dimmer, 0-100%
2| Sections| 000- 255| 1 st **segment,
0-100%
3| | 000- 255| 2 nd ****segment, 0-100%
4| | 000- 255| 3 rd ****segment, 0-100%
5| | 000- 255| 4 th ****segment, 0-100%
6| Strobe| 000- 255| Strobe, from slow to
fast
7| Macro| 000- 255| Macro
8| Speed| 000- 255| Speed for channel 7**
is a leading developer of lighting products, including intelligent DMX moving heads, wireless battery operated DMX effects, static washes, sound-activated club effects, strobes & blacklights, LED lighting, Fog and special effects machines, lasers and indoor and outdoor architectural lighting, as well as lighting controllers and protective bags.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>