CRYSTORAMA DUM-9807-GE Dumont Outdoor 3 Light Wall Mount Instruction Manual
- June 12, 2024
- CRYSTORAMA
Table of Contents
CRYSTORAMA DUM-9807-GE Dumont Outdoor 3 Light Wall Mount
Product Information
The product model number is DUM-9807-GE. The product requires electrical
installation by a licensed electrician in accordance with the National
Electric Code and the appropriate local electrical codes. The product measures
9.25×9.25 and requires 3-Candelabra Bulb 40 Watts Recommended 60 Watts Max
Bulb (not included). The use of LED bulbs for extended use is recommended.
The product is supplied with mounting hardware including 3 screws and a wire
nut. The post is not included. The glass size is 9.3 x 11.5 with a thickness
of 1/8 inch.
The product comes with a warning that it contains Lead, which is known to the
State of California to cause cancer and/or birth defects or reproductive harm.
For more information, visit
www.P65Warnings.ca.gov.
Product Usage Instructions
Installation:
- Place the fixture over the post and mark 3 points on the post at the center of the holes on the post fitter.
- Drill the holes at the marked points.
- Connect the fixture wires, then place the fixture over the post by aligning the holes on the fitter with the holes drilled on the post. Secure by tightening with side screws.
Glass Replacement:
- Remove the screws on the top of the cage and remove the cage.
- Remove the L-shaped metal strap by unscrewing the screws.
- Smooth out the silicone glue along the glass channel, prior to placing in the new glass panel.
- Put the new glass panel on and secure it with the L-shaped metal strap and screws.
ASSEMBLY INSTRUCTION
- WARNING Electrical Danger mum Power it
- All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
- You will need 3-Candelabra Bulb 40 Watts Recommended 60 Watts Max Bulb not included USE LED BULBS FOR EXTENDED USE This fixture is WET rated
Dimension
How to Install
- Place the fixture over the post and mark 3 points on the post at the center of the holes on the post fitter.
- Drill the holes at the marked points.
- Connect the fixture wires, then place the fixture over the post by aligning the holes on the fitter with the holes drilled on the post.Secure by tightening with side screws.
How to change the glass
- Remove the screws on the top of the cage and remove the cage
- Remove the L-shaped metal strap by unscrewing the screws.
- Smooth out the silicone glue along the glass channel, prior to placing in the new glass panel.
- Put the new glass panel on and secure it with the L-shaped metal strap and screws
Sketch Map
Part Number
- A. Mounting Hardware
- (3)Screw
- (3)Wire Nut
- B. (1)Base;03.4″x3.5″H
- C. (3)Socket
- D. (1)Bottom cage
- E. (4)Glass;XMO9802GEGLA11.5IN
- F. (1)Top cage
- WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.
- For more information go towww.P65Warnings.ca.gov
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>